Worx WX801.9 - Инструкция по эксплуатации - Страница 10

10

EN

ADDITIONAL SAFETY INSTRUCTIONS FOR GRINDING 

AND CUTTING-OFF OPERATIONS 

SAFETY WARNINGS SPECIFIC FOR GRINDING AND ABRASIVE CUTTING-

OFF OPERATIONS:

a)   Use only wheel types that are recommended for your power tool and 

the specific guard designed for the selected wheel. 

Wheels for which the 

power tool was not designed cannot be adequately guarded and are unsafe.

b)   The grinding surface of centre depressed wheels must be mounted 

below the plane of the guard lip. 

An improperly mounted wheel that projects 

through the plane of the guard lip cannot be adequately protected.

c)   The guard must be securely attached to the power tool and 

positioned for maximum safety, so the least amount of wheel is 

exposed towards the operator. 

The guard helps to protect the operator from 

broken wheel fragments, accidental contact with wheel and sparks that could ignite 

clothing.

d)   Wheels must be used only for recommended applications. For 

example: do not grind with the side of cut-off wheel. 

Abrasive cut-off 

wheels are intended for peripheral grinding, side forces applied to these wheels may 

cause them to shatter.

e)   Always use undamaged wheel flanges that are of correct size and 

shape for your selected wheel. 

Proper wheel flanges support the wheel thus 

reducing the possibility of wheel breakage. Flanges for cut-off wheels may be different 

from grinding wheel flanges.

f)   Do not use worn down wheels from larger power tools. 

Wheel intended 

for larger power tool is not suitable for the higher speed of a smaller tool and may 

burst.

ADDITIONAL SAFETY WARNINGS SPECIFIC FOR 

ABRASIVE CUTTING-OFF OPERATIONS:

a)   Do not “jam” the cut-off wheel or apply excessive pressure. Do not 

attempt to make an excessive depth of cut. 

Overstressing the wheel 

increases the loading and susceptibility to twisting or binding of the wheel in the cut 

and the possibility of kickback or wheel breakage.

b)   Do not position your body in line with and behind the rotating wheel. 

When the wheel, at the point of operation, is moving away from your body, the 

possible kickback may propel the spinning wheel and the power tool directly at you.

c)   When wheel is binding or when interrupting a cut for any reason, 

switch off the power tool and hold the power tool motionless until 

the wheel comes to a complete stop. Never attempt to remove the 

cut-off wheel from the cut while the wheel is in motion otherwise 

kickback may occur. 

Investigate and take corrective action to eliminate the cause 

of wheel binding.

d)   Do not restart the cutting operation in the workpiece. Let the wheel 

reach full speed and carefully re-enter the cut. 

The wheel may bind, walk 

up or kickback if the power tool is restarted in the workpiece.

e)   Support panels or any oversized workpiece to minimize the risk of 

wheel pinching and kickback. 

Large workpieces tend to sag under their own 

weight. Supports must be placed under the workpiece near the line of cut and near the 

edge of the workpiece on both sides of the wheel.