Makita BO6050J - Инструкция по эксплуатации - Страница 4

4

ENGLISH

tool is maintained.

2. 

Follow instruction for lubricating and chang-

ing accessories.

3. 

Keep handles dry, clean and free from oil and 

grease.

Sander safety warnings

1. 

Always use safety glasses or goggles. 

Ordinary eye or sun glasses are NOT safety 

glasses.

2. 

Hold the tool firmly.

3. 

Do not leave the tool running. Operate the tool 

only when hand-held.

4. 

This tool has not been waterproofed, so do not 

use water on the workpiece surface.

5. 

Ventilate your work area adequately when you 

perform sanding operations.

6. 

Some material contains chemicals which may 

be toxic. Take caution to prevent dust inhala-

tion and skin contact. Follow material supplier 

safety data.

7. 

Use of this tool to sand some products, paints 

and wood could expose user to dust contain-

ing hazardous substances. Use appropriate 

respiratory protection.

8. 

Be sure that there are no cracks or breakage 

on the pad before use. Cracks or breakage 

may cause a personal injury.

SAVE THESE INSTRUCTIONS.

WARNING:

DO NOT let comfort or familiarity 

with product (gained from repeated use) replace 

strict adherence to safety rules for the subject 

product. MISUSE or failure to follow the safety 

rules stated in this instruction manual may cause 

serious personal injury.

FUNCTIONAL 

DESCRIPTION

CAUTION:

Always be sure that the tool is 

switched off and unplugged before adjusting or 

checking function on the tool.

Switch action

CAUTION:

Before plugging in the tool, always 

check to see that the slide switch actuates prop-

erly and returns to the "OFF" position when the 

rear of the slide switch is depressed.

CAUTION:

When locking tool in "ON" position 

apply caution and maintain firm grasp on tool.

To start the tool, slide the slide switch toward the "I 

(ON)" position. For continuous operation, press the 

front of the slide switch to lock it.

1

1. Slide switch

To stop the tool, press the rear of the slide switch, then 

slide it toward the "O (OFF)" position.

1

1. Slide switch

Speed adjusting dial

1

1. Speed adjusting dial

The rotating speed can be changed by turning the 

speed adjusting dial to a given number setting from 1 to 

5. Higher speed is obtained when the dial is turned in 

the direction of number 5. And lower speed is obtained 

when it is turned in the direction of number 1.

Refer to the table for the relationship between the num-

ber settings on the dial and the approximate rotating 

speed.