VITEK VT-1804 - Инструкция по эксплуатации - Страница 34

14

 ENGLISH

sponding  center  for  recycling  of  it.  Do  not 
burn  the  vacuum  cleaner  even  if  it  is  badly 
damaged  without  removing  the  battery  to 
avoid the battery explosion.

 •

It  is  recommended  to  remove  the  battery  (5) 
for long storage of the vacuum cleaner.

 •

Press on the battery (5) compartment lid locks 
and remove the lid.

 •

Remove the battery (5) and remove the socket 
from the slot on the plate. 

STORAGE

 •

Before  taking  the  vacuum  cleaner  away  for 
long  term  storage  clean  its  body,  the  dust 
compartment (20) and the filters (17, 19).

 •

Pour  the  water  out  of  the  water  tank  (13), 
wash  and  dry  the  wet  floor  cleaning  attach-
ment (39).

 •

Remove the battery from the remote control.

 •

Use the original package for storage.

 •

Keep  the  vacuum  cleaner  in  a  dry  cool  place 
out of reach of children and disabled persons.

TABLE OF LIGHT AND SOUND SIGNALS OF THE VACUUM CLEANER
Light signals

Vacuum cleaner state

Color indication

Battery charging mode

Flashing purple 

Battery charging is finished

Blue 

Ready mode

Flashing blue 

Malfunction

Flashing red

Low battery

Flashing red

Sound signals

Number of sound 
signals

Malfunction

Solution

1

•

The vacuum cleaner got stuck

Move the vacuum cleaner to a free place.

2

••

Dust bin is malfunctioning

Remove the dust bin and install it again.

3

•••

The driving wheel or the side 
brushes are damaged.

If they don‘t rotate, contact the service 
center.

4

••••

Anti-drop sensor is malfunctioning. Clean the sensors from dust.

Possible troubles and troubleshooting

№ Malfunction

Possible causes

Solution

1

The battery doesn‘t 
charge.

The vacuum cleaner is set 
improperly on the charging 
station.

Make sure that the contact points for 
battery charging on the vacuum cleaner 
body and on the charging station are clean. 
If necessary, wipe the contact points.
Slightly move the vacuum cleaner body  
by hands to provide better contact with  
the charging station.

The charging station power 
adapter is disconnected 
from the mains. 

Connect the charging station and plug  
the power adapter to the mains socket. 

The battery is fully 
discharged.

Place the vacuum cleaner on the charging 
station by hands, after 3 minutes remove 
the vacuum cleaner from the charging 
station, repeat these battery charging 
cycles at least 3 times; then charge  
the battery in a normal cycle.

IM VT-1804.indd   14

7/11/19   9:30 AM