VITEK VT-1802 - Инструкция по эксплуатации - Страница 11

11

ENGLISH          

Possible troubles and troubleshooting

№ Malfunction

Possible causes

Solution

1

The battery doesn‘t 
charge.

The vacuum cleaner is set 
improperly on the charging station.

Make sure that the contact 
points for battery charging on 
the vacuum cleaner body and on 
the charging station are clean. 
If necessary, wipe the contact 
points.
Slightly move the vacuum cleaner 
body by hands to provide better 
contact with the charging station. 

The charging station power 
adapter is disconnected from the 
mains. 

Connect the charging station and 
plug the power adapter to the 
mains socket. 

The battery is fully discharged.

Place the vacuum cleaner on the 
charging station by hands, after  
3 minutes remove the vacuum 
cleaner from the charging station, 
repeat these battery charging 
cycles at least 3 times; then 
charge the battery in a normal 
cycle.

2

The vacuum 
cleaner gives 
alarms, periodically 
switches  
on and off.

It is possible that foreign objects 
(wires, threads, hanging curtains, 
etc.) have been wound onto the 
driving wheels of the vacuum 
cleaner.

Remove the foreign objects from 
the driving wheels and from the 
floor.

3

The vacuum cleaner 
finishes cleaning 
ahead of time and 
spontaneously 
returns to the 
charging station.

If the battery charge is too low for 
the room cleaning, the vacuum 
cleaner automatically 
returns to the charging station.

It is normal. 
Do not interfere with the vacuum 
cleaner operation.

The operation time of the 
vacuum cleaner depends on the 
cleaning area, floor surface, room 
configuration and the selected 
cleaning mode.

4

The vacuum cleaner 
doesn‘t switch on 
in the scheduled 
operation mode.

The vacuum cleaner  
is switched off.

Switch the vacuum cleaner on by 
pressing and holding the start/
stop button.

The vacuum cleaner battery is 
discharged.

Always leave the vacuum cleaner 
on the charging station if you 
are going to use the scheduled 
operation mode. 

5

The vacuum cleaner 
doesn‘t respond to 
the remote control.

The battery in the remote control 
is discharged and has to be 
replaced.

Remove the battery holder from 
the remote control, remove the 
old battery, install a new one 
strictly following the polarity and 
install the holder into the remote 
control.

IM VT-1802.indd   11

14.06.2019   15:07:07