Bosch GOP 12V-28 - Инструкция по эксплуатации - Страница 17

 English | 

17

Bosch Power Tools

1 609 92A 2LW | (16.1.17)

When no LED lights up after switching on, then the battery is 
defective and must be replaced.

Changing the Tool



Before any work on the machine itself (e. g. mainte-

nance, tool change, etc.) as well as during transport 

and storage, remove the battery from the power tool. 

There is danger of injury when unintentionally actuating 
the On/Off switch.



Wear protective gloves when changing application 

tools/accessories. 

Contact with the application tool/

accessory can lead to injuries.

Selecting the Application Tool/Accessory

The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.

LED

Capacity

Continuous lighting 3 x green

≥2/3

Continuous lighting 2 x green

≥1/3

Continuous lighting 1 x green

< 1/3

Flashing light 1 x green

Reserve

Flashing light 3 x green

Empty

Accessory

GOP 12V-28

Accessory

Material

Application

BIM segment saw 
blade

Wooden materials, 
Plastic,
Non-ferrous metals

Separating and plunge cuts; also for sawing close to edges, 
in corners and hard to reach areas;
example: shortening already installed bottom rails or door 
hinges, plunge cuts for adjusting floor panels

Base plate for 
sanding, series 
Delta 93 mm

Depends on sanding sheet  Sanding surfaces close to edges, in corners or hard to 

reach areas;
depending on the sanding sheet for, e. g., sanding wood, 
paint, varnish, stone

Fleeces for cleaning and for texturing wood, removing rust 
from metal and for keying varnishes, polishing felt for pre-
polishing

Profile sander

Wood,
Pipes/Profile,
Paint,
Varnishes,
Filler,
Metal

Convenient, efficient sanding of profiles up to a diameter of 
55 mm;
Red sanding sheets for sanding wood, pipes/profiles, 
varnishes, fillers and metal

BIM plunge cut 
saw blade, wood 
and metal

Softwood,
Soft plastics,
Plasterboard,
Thin-walled aluminium 
and non-ferrous metal 
profiles,
Thin sheet metals,
Non-hardened nails and 
screws

Smaller separating and plunge cuts;
example: cutting an opening for sockets, flush cutting a 
copper pipe, plunge cuts in plasterboard

Filigree adjustment work in wood;
example: sawing openings for locks and fittings

HCS plunge cut 
saw blade, wood

Wooden materials,
Soft plastics

Separating and deep plunge cuts; also for sawing close to 
edges, in corners and hard to reach areas;
example: narrow plunge cut in solid wood for installing a 
ventilation grid

Bi-metal plunge 
cut saw blade, 
hardwood

Hardwood,
Laminated panels

Plunge cuts in laminated panels or hardwood;
example: installing skylights

OBJ_BUCH-2853-001.book  Page 17  Monday, January 16, 2017  1:56 PM