BRAYER BR4260 - Инструкция по эксплуатации - Страница 8

8

EN

– If you detect any bulgings of the battery body, stop 

using the battery immediately.
– Avoid the battery terminals circuit, it may cause burns 

or fire.
– Do not discard the battery with usual household 

waste, apply to a specialized center for further recycling.

•  Install the battery (10) to the installation place until 

the lock (9) clicking.

• 

Before using the unit for the first time or after a long 

period of inactivity, charge the battery (10).

•  Install the base (1) in a convenient place near a 

mains socket.

•  Install the vacuum cleaner on the base (1).

• 

Insert the power adapter (22) connection cord jack 

(23) into the socket (8).

• 

Plug the power adapter (22) into the mains socket, 

the indicators (5) will light up.

• 

The battery (10) charging level is shown with the 

indicators (5).

• 

Full charging of the battery (10) takes about 4 hours; 

the indicators (5) will be flashing. When the battery 

(10) is fully charged, the indicators (5) will glow 

constantly.

• 

When the battery (10) is fully charged, the indicators 

(5) will go out after 3 minutes. Then unplug the power 

adapter (22).

• 

Remove the power adapter (22) connection cord jack 

(23) from the socket (8).

Notes:

– charge the battery (10) at the temperature from +5°C 

to +35°C.
– if you didn’t use the vacuum cleaner for more than 2-3 

months, fully charge the battery (10) before using the 

vacuum cleaner.

USING THE VACUUM CLEANER
ATTENTION!

– If the suction power of the vacuum cleaner decreases 

rapidly while cleaning, switch it off immediately and 

check the extension pipe (12) for obstruction. Remove 

the obstruction and only then continue cleaning.
– Do not use the vacuum cleaner to collect burning or 

smoking cigarettes, cinders, plaster or concrete dust, 

flour or ashes.

– The vacuum cleaner is not intended for collecting 

water or other liquids.
– Do not use the vacuum cleaner in places where 

aerosols are used or sprayed, and in proximity to highly 

inflammable liquids, do not use the vacuum cleaner in 

the places where such liquids are stored.

ASSEMBLING THE VACUUM CLEANER
Attaching the extension pipe and attachments

•  Insert the extension pipe (12) into the vacuum 

cleaner air inlet until the clamp (11) clicking (pic. 1).