Пылесос VITEK VT-1829 R/B - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
6
Note: cleaning of the dust collection container
after every use of the vacuum cleaner is recom-
mended. The full dustbin indicator (8) will re-
mind you of the need to clean the container and
filters on time.
Cleaning the filters (19, 20) in the dust col-
lection container
Keep the filters in the dust collection container
clean, because the effectiveness of the vacuum
cleaner depends on this. Clean the HEPA filter
no less than two or three times a year, or more
if they get very dirty. Change the HEPA filter as
needed, but not less than once a year. The pre-
liminary filter (20) should be cleaned when dirty.
• Turn off the vacuum cleaner and disconnect it
from power, remove the container as clean out
the dust and trash.
• Remove the upper dust collection container
lid (18) with the filter block (19, 20) (Pic. 2).
• Clean out the dust and trash from the prelimi-
nary screen filter (20).
• Gripping the lower base of the filter (19), turn it
counter-clockwise and remove.
• Wash the preliminary filter (20) and HEPA filter
(19) under a stream of warm water (Pic. 5). Do
not put in dishwasher.
• Dry the filters. Do not dry the filters with a hair
dryer (Pic. 6).
• Wash the containers (20) and the upper lid
(18) of the dust collector and dry them.
Assembling the dustbin container:
• Attach the filter block (19) to the upper lid by
turning it in a clockwise direction until it locks,
otherwise the lid locking mechanism will not
work and the lid (18) will not fit onto the con-
tainer (12) (Fig. 2).
• Install the preliminary screen filter (20) onto
the filter (19).
• Close the upper lid of the container.
• Put the assembled container in place by lightly
pressing on it until it locks.
Cleaning the exhaust filters
• Open the lid to the exhaust filters (14).
• Remove the filters (13) and wash them under a
stream of warm water.
• Reinstall the filters (13) and close the lid (14).
Note: wash the exhaust filters (13) at least once
per year.
Air aromatizing (Fig.4)
To aromatize the air in the room while vacuum-
ing, use aromatic pellets.
• Remove the containers (15) by lightly pressing
on the container lid (16).
• Remove the lid (16) from the container (16),
pour aromatic pellets into the container, close
the lid (16).
• Replace the container.
Note: replace the aromatic pellets as neces-
sary.
Vacuum cleaner body
• W ipe the vacuum cleaner body with a moist
cloth.
• Do not allow liquids to enter the vacuum
cleaner body.
• Do not use solvents or abrasive cleaners to
clean the vacuum.
Storage
Use the brush “parking” place (29) during breaks
in vacuuming or when storing the vacuum clean-
er.
Technical characteristics:
Power Supply:
230V ~ 50Hz
Power Usage:
2000 Watts
Suction Power:
450 Watts
Dustbin Capacity: 2.2 L
The manufacturer reserves the right to change
t h e d e v i c e ' s c h a ra c t e r i s t i c s w i t h o u t p r i o r
notice.
Service life - no less than 5 years.
GUARANTEE
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the
C o u n c i l D i r e c t i v e 8 9 / 3 3 6 / E E C
and to the Low Voltage Regulation
(73/23 EEC)
ENGLISH
Vt-1829.indd 6
Vt-1829.indd 6
28.03.2006 11:50:06
28.03.2006 11:50:06