ProfiCare PC-BS 3037 A - Инструкция по эксплуатации - Страница 49

PC-BS3037A_IM 

27.05.19

49

• 

You may attach this brush both directly onto the connec

-

tion on the handset as well as onto the connection of the 

already mounted suction pipe.

• 

To release the nozzle, simply pull it off.

Assembly the Wall Holder

Please take a look at Figures C and D on page 3.

Inserting the Plug of the Power Adapter

If you want to use the wall holder also as the charging sta-

tion, attach the plug of the power adapter first (Fig. C)

1.  Connect the power supply plug to the slot on the back of 

the charging unit.

2.  Firmly push the plug into the terminals. It must audibly 

snap into place.

3.  Secure the cable in the right or left cable guide.

Fastening the Wall Holder

  WARNING:

Make sure beforehand whether there are cables in the 

wall which could be damaged!

  CAUTION:

Place the wall holder so that the appliance is not exposed 

to direct sunlight or other heat sources.

  NOTE:

If you would like to simultaneously use the wall mount as 

a charging station, there must be a power outlet nearby.

1. 

Measure the height for the wall holder. Hold the vacuum 

cleaner against the wall with the suction pipe and the 

floor nozzle installed.

2. 

Hold the wall holder against the wall as shown on page 3 

(Fig. D). Mark 2 drill holes.

3.  Drill the holes and insert the wall plugs into the wall.

4. 

Insert the screws through the holes of the wall holder.

5. 

Tighten the screws with a screwdriver hand-tight.

Charging the Rechargeable Battery

  CAUTION:

Do not charge the rechargeable battery unsupervised.

1. 

Turn off the appliance.

2.  Connect the power adapter with the connection 

socket (10). If you have prepared the wall holder as a 

charging station, suspend the appliance from the wall 

holder.

3. 

Connect the power adapter to a certified wall socket. 

Charge the appliance for approx. 5 hours before first-

time use.

  NOTE:

• 

The indicator lights show the state of charge of the 

rechargeable battery. (25 %, 50 %, 100 %)

• 

The appliance has electronic charge control, which 

prevents overcharging.

•  Charging is completed when all 3 indicator lights 

are lit.

•  In case the appliance is removed from the charging 

station or disconnected from the power adapter, the 

indicator lights go out.

•  It is normal for the appliance to heat up during 

charging.

4. 

Disconnect the power 

adapter from the outlet once 

the rechargeable battery has 

been charged completely.

5. 

To remove the appliance 

from the charging station, 

press the release latch on top 

of the wall mount.

  NOTE:

Even when switched off, 

the rechargeable battery 

discharges continuously. If the 

appliance is out of use for a 

longer period of time, charge 

the rechargeable battery at 

least once every 4 to 6 weeks.

Using the Appliance

You can use the appliance as a floor vacuum cleaner or as 

a handheld and upright vacuum cleaner (basic unit).

1.  Disconnect the appliance from the power adapter.

2. 

Turn on the appliance.

3.  If you would like to tilt the suction pipe at the joint, press 

the release (14).

  NOTE:

•  We recommend the higher power level for using the 

appliance with the floor nozzle. Press the 

MAX

 button.

•  During operation, depending on the charging capacity 

of the rechargeable battery, 1 to 3 indicator are lit.

•  We recommend recharging the battery once the indica-

tor lights show a remaining capacity of only 25 %.

•  Once the capacity of the rechargeable battery is al-

most reaching its end, the last indicator light will flash. 

To avoid a deep discharge of the rechargeable battery, 

the motor will shut off the appliance accordingly. Re-

charge the battery.

End of Operation

1. 

Turn off the appliance.

2.  If you have already installed the wall holder, hang up the 

vacuum cleaner. 

Maintenance

The Filter System

Your appliance features 3 filters. The common dust bag 

system has been replaced by a transparent dust collector. 

The higher flow speed of the collector allows for heavy dirt 

and smallest floating particles to be separated from the 

“sucked-in air”.
It is thus not necessary to buy dust bags.

The filters must be cleaned periodically.

  CAUTION:

• 

Never wash the filter in the washing machine.

•  Do not use a hairdryer for drying.

•  Only put the appliance back into operation when all 

filters are completely dry and correctly assembled.

The Filter Unit

The filter unit is composed of:

• 

Fine material filter

• 

Coarse filter

Proceed as follows to clean  

the filter unit:

Emptying the Dust Collector

1.  Disconnect the appliance from the power adapter.

2.  If necessary, remove the suction tube or the nozzle 

attachment from the appliance.

3.  Please take a look at Figure A on page 3. Press the 

 button on the dust container to release it from the 

handset.

4.  Pull out the fine material filter on the coloured piece of 

fabric.

5. 

Pull out the coarse filter on its handle to remove it from 

the dust container.

6. 

Empty the contents of the dust collector.

Cleaning the Filters

1. 

Hold both filters over a garbage can and tap out the dust. 

You may also brush out the fine material filter. In case of 

heavy staining, clean the filters under running water.

2. 

Let the filters air-dry completely before refitting them!

3.  Wipe the dust collector with a damp cloth and then wipe 

it dry.