Miele SGMA3 Complete C3 Comfort - Инструкция по эксплуатации - Страница 65

en

65



Open the dust compartment lid (Fig.
09).



Lift the exhaust filter and remove it
(Fig. 40).



Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position (Fig. 41).



If you are using exhaust filter 

c

, 

d

 or

e

, you must also activate the

timestrip

®

 filter change indicator (Fig.

11).

After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 12).

If you wish to fit an AirClean exhaust
filter, see “Replacing one type of ex-
haust filter with another”.



Close the dust compartment lid.

Replacing one type of exhaust filter
with another (Fig. 08)

Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters:

a AirClean

b AirClean Plus 50 (light blue)

c Silence AirClean 50 (grey)

d Active AirClean 50 (black)

e HEPA AirClean 50 (white)

Do not use more than one exhaust
filter at a time.

When changing the filter, please note

1. If you wish to replace exhaust filter 

a

with filter 

b

, 

c

, 

d

 or 

e

, it is essential

that you remove the filter grille before
you fit the new exhaust filter.

If you are using exhaust filter 

c

, 

d

 or

e

, you must also activate the

timestrip

®

 filter change indicator

(Fig. 11).

2. If you wish to replace exhaust filter 

b

,

c

, 

d

 or 

e

 with filter 

a

, it is essential

that you also fit the filter grille* (Fig.
39).

* Filter grille – see “Optional ac-
cessories”

Maintenance indicator with reset but-
ton (Fig. 42)

Some models are fitted with a mainten-
ance indicator.

The indicator lights up after approxim-
ately 50 hours of operation, which is
equivalent to about a year of average
use. The level of soiling of the motor
protection filter and the exhaust filter
must be checked at this point.

The indicator must be reset each time
the filters are replaced. The vacuum
cleaner must be switched on to do this.



Press the reset button.

The maintenance indicator will go out
and reset to zero.

The indicator can only be reset by
pressing the reset button after the light
has come on. Pressing the button at
any other time will have no effect.