Philips SRM5100 - Инструкция по эксплуатации - Страница 7

Manually setting the remote control

Example  of TV  (TV, LCD TV, plasma TV, projector, HD TV):

1

Turn on the TV manually or use the original remote control.
Tune in to channel 1.

2

Look up the brand of your TV in the code list 
at the back of this manual. One or more four-
figure codes are shown for each brand. Note
the first code.

Be careful! There are separate tables for TV, STB
and AMP.

On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.

Make sure you use the codes from the correct table.

3

Press the 

MODE

key to select TV.

Press the key until the TV LED lights up.

–

The LED lights up for 10 seconds and then
goes out.

4

Keep keys 

1

and 

3 pressed simultaneously 

for three seconds

until the TV LED flashes

twice and then remains lit.

5

Then enter the code noted in step 2 using the digit keys.

–

The TV LED key will now flash twice. If the LED flashes once for an
extended period, the code has not been entered properly or the wrong
code has been entered. Star t again from step 2.

6

Point the SRM 5100 at the TV and check that it responds as it should.

–

If the TV responds to all of the key commands, the SRM 5100 is ready
for use. Do not forget to note your code.

•

If the device does not respond at all, or not to all of the key
commands, start again from step 2 and try the next code from
the list.

7

Instructions for use

English

SRM5100_Def  31-05-2007  16:43  Pagina 7