Smeg PLA4645X7 - Инструкция по эксплуатации - Страница 7

User instructions

INTERRUPTING A PROGRAM

In order to interrupt a running program it is necessary:

•

 to 

press 

the 

START/STOP (5)

 for some seconds until when the

writting “

Time to end

” remains lit on the display (confirmation beep).

At this point,it is possible to start the cycle again, otherwise:

TO CHANGE A PROGRAM

To change the running program it is necessary:

•

to interrupt the running program (see “

I

NTERRUPTING A PROGRAM

”);

•

select the new program;

•

to press again the 

START/STOP

 button

 (5)

 to make start the new

program.

STOPPING A PROGRAM

To stop a program in progress, it must first be interrupted (see
"

I

NTERRUPTING A PROGRAM

").

Now press buttons 

P1

+

P2

 simultaneously and

the first three program lights will come on.

The display will show "

P0

" and the dishwasher will immediately switch to

the end of the cycle and drain the tank (during this process, the "

Time to

end

" message will flash). When the drain procedure ends, the end of

cycle message "

End

" appears on the display.

In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “

S

TART PROGRAM

”. The  program will resume from the point in

which it was interrupted.

In case that the tub temperature is higher than 50°C the program
will start about 30 seconds later.

The washing cycle will not take place if the dishwasher door is left open or
not properly closed.