Kuppersberg GS 6020 - Инструкция по эксплуатации - Страница 24

24

TECHNICAL PASSPORT

ENGLISH

Dishwasher

Before Calling for Service

Reviewing the charts on the following pages may make you be free of calling for service.

Problem

Possible Causes

What To Do

Dishwasher 

doesn't run

Fuse blown, or the 

circuit breaker acted

Replace fuse or reset circuit breaker. Remove any other 

appliances sharing the same circuit with the dishwasher

Power supply is not 

turned on

Make sure the dishwasher is turned on and the door is closed 

securely. Make sure the power cord is properly plugged into the 

wall socket.

Water pressure is 

low

Check that the water supply is connected properly and the 

water is turned on.

Drain pump 

doesn't stop

Overfl ow

The system is designed to detect an overfl ow. When it does, it 

shuts off the circulation pump and turns on the drain pump.

Noise

Some audible 

sounds are normal

Sound from detergent cup opening.

Utensils are 

not secure in 

the baskets or 

something small 

has dropped into 

the basket

To ensure everything is secured in the dishwasher

Motor hums

Dishwasher has not been used regularly. If you do not use 

it often, remember to set it to fi ll and pump out every week, 

which will help keep the seal moist.

Suds in the 

tub

Improper detergent

Use only the special dishwasher detergent to avoid suds. If 

this occurs, open the dishwasher and let suds evaporate. Add 1 

gallon of cold water to the tub. Close and latch the dishwasher, 

then start the "pre-rinse" wash cycle to drain out the water. . . 

Repeat if necessary.

Spilled rinse agent

Always wipe up rinse agent spills immediately.

Stained tub 

interior

Detergent with 

colorant was used

Make sure that the detergent is the one without colorant.

Dishes and 

fl atware not 

clean

Improper program

Improper basket 

loading

Select a stronger programme.

Make sure that the action of the detergent dispenser and spray 

arms are not blocked by large dishware.

Spots and 

fi lming on 

glasses and 

fl atware

1. 

Extremely hard 

water

2. Low inlet 

temperature

3. Overloading the 

dishwasher

4. Improper loading

5. Old or damp 

powder detergent

6. Empty rinse agent 

dispenser

7.  Incorrect dosage 

of detergent

To remove spots from glassware:

1. Take out all metal utensils out of the dishwasher.

2. Do not add detergent.

3. Choose the longest cycle.

4. Start the dishwasher and allow it to run for about 18 to 22 

minutes, then it will be in the main wash.

5. Open the door to pour 2 cups of white vinegar into the 

bottom of the dishwasher.

6. Close the door and let the dishwasher complete the cycle. If 

the vinegar does not work: Repeat as above, except use 1/4 

cup (60 ml)of citric acid crystals instead of vinegar.