Elenberg DW-600 - Инструкция по эксплуатации - Страница 18

1

6.  If  for  any  reason  you  are  unable  to  stop  the  leak  yourself  please  seek  advice 

from a qualified plumber.

7. 

The minimum height clearance required to install your dishwasher on a countertop 
surface with overhead cupboards is 19” (48cm).

8.  Make sure there is an electrical power supply within easy reach of the machine. 

The power cord is 6 feet (182.8cm) long.

9.  The dishwasher must be installed on a ‘solid’ level surface.
10.  To level the dishwasher, adjust the 4 level screws (feet) under the dishwasher.

For  best  operating  results,  incoming  water  pressure  should  be  between  0.3  and  10 
bar.
FOR BEST RESULTS:
•  Your  dishwasher  cleans  by  spraying  a  mixture  of  hot  clean  water  and  detergent 

(under  pressure)  against  the  soiled  surface  of  dishes.    The  water  is  pumped 
through  a  rotating  spray  arm,  drained  through  a  filter  removing  food  and  soiled 
particles and pumped back through the spray arm.

•  Soiled water is pumped out and replaced with clean water at the end of each cycle 

(the number of times depends on the cycle being used). For best cleaning results, 
the water temperature must be at least 55

0

C.  To prevent dishwasher damage, the 

temperature of the incoming water supply should not exceed 60

0

C.

NOTE:  Hard  Water  conditions  will  adversely  affect  wash  ability  performance  of 

your  dishwasher.    Hard  Water  conditions  will  also  contribute  to  “Lime”  (white 
film  substance)  deposits  and/or  “Scaling”  on  the  stainless  steel  surface  of  the 
dishwasher  tub  and  “Heater  Element”  located  in  the  sump  underneath  the 
removable filter screen.  To assist in minimizing these conditions, it is recommended 
to periodically operate/rinse the inside of the dishwasher (empty) using 1 cup of 
white vinegar (at least once a week).

•  Close the hot water supply at the stopcock.
•  Disconnect the power supply cord.
•  Disconnect the inlet hose assembly from the water supply.  When the dishwasher 

is not in use, place/store the hose on the hanger hose bracket located on the rear 
wall of the dishwasher cabinet.

•  Appliances  that  are  to  be  discarded  must  be  made  unusable.  Pull  off  the  plug, 

remove cable and make the door lock and latch unusable

IMPORTANT
 

Once you open the water supply line, (even if it is closed immediately there after) 
the water inlet hose will be pressurized.

CAUTION
 

DO NOT LET CHILDREN DISCONNECT THE DISHWASHER.  Close supervision 
of children is always important around appliances.

WATER PRESSURE

DISCONNECTINg YOUR DISHWASHER