Electrolux ESL 4500LO - Инструкция по эксплуатации - Страница 19

Refer to 

"Before first use"

, 

"Daily use"

, or 

"Hints and

tips"

 for other possible

causes.

Once you have checked the appliance,

deactivate and activate the appliance. If

the problem occurs again, contact an

Authorised Service Centre.
For alarm codes not described in the

table, contact an Authorised Service

Centre.

12.1 

The washing and drying results are not satisfactory

Problem

Possible cause and solution

Poor washing results.

• Refer to 

"Daily use"

, 

"Hints and tips"

 and basket

loading leaflet.

• Use more intensive washing programs.

• If you use multi-tablets, always switch on the option

Multitab.

Poor drying results.

• Tableware has been left for too long inside a closed

appliance.

• There is no rinse aid or the dosage of rinse aid is not

enough. Set the rinse aid dispenser to a higher level.

• Plastic items may need to be towel dried.

There are whitish streaks or

bluish layers on glasses and

dishes.

• The release quantity of rinse aid is too much. Adjust

the rinse aid selector to a lower position.

• The quantity of detergent is too much.

There are stains and dry wa-

ter drops on glasses and

dishes.

• The released quantity of rinse aid is not sufficient.

Adjust the rinse aid selector to a higher position.

• The quality of the rinse aid can be the cause.

The dishes are wet.

• The programme does not have a drying phase or

has a drying phase with low temperature.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the cause.

• The quality of the multi-tablets can be the cause. Try

a different brand or activate the rinse aid dispenser

and use rinse aid and multi-tablets together.

The interior of the appliance

is wet.

• This is not a defect of the appliance. it is caused by

the humidity in the air that condenses on the walls.

Unusual foam during wash-

ing.

• Use the detergent for dishwashers only.

• There is a leak in the rinse aid dispenser. Contact an

Authorised Service Centre.

Traces of rust on cutlery.

• There is too much salt in the water used for washing.

Refer to 

"The water softener"

.

• Silver and stainless steel cutlery were placed togeth-

er. Avoid to put silver and stainless steel items close

together.

ENGLISH

19