Electrolux ESL 4500LO - Инструкция по эксплуатации - Страница 18

Problem and alarm code Possible cause and solution

The appliance does not fill

with water.
The display shows 

.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clog-

ged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not

drain the water.
The display shows 

.

• Make sure that the sink spigot is not clogged.

• Make sure that the filter in the outlet hose is not clog-

ged.

• Make sure that the interior filter system is not clogged.

• Make sure that the drain hose has no kinks or bends.

The anti-flood device is on.
The display shows 

.

• Close the water tap and contact an Authorised Service

Centre.

The appliance stops and

starts more times during

operation.

• It is normal. It provides optimal cleaning results and

energy savings.

The program lasts too long. • An energy-saving option has been selected.

• If the delayed start option is set, cancel the delay set-

ting or wait for the end of the countdown.

The remaining time in the

display increases and skips

nearly to the end of pro-

gram time.

• This is not a defect. The appliance is working correctly.

The options of the program

have to be set again every

time.

• To save your favourite configuration use option MyFa-

vourite.

Small leak from the appli-

ance door.

• The appliance is not level. Loosen or tighten the ad-

justable feet (if applicable).

• The appliance door is not centred on the tub. Adjust

the rear foot (if applicable).

The appliance door is diffi-

cult to close.

• The appliance is not level. Loosen or tighten the ad-

justable feet (if applicable).

• Parts of the tableware are protruding from the bas-

kets.

Rattling/knocking sounds

from inside the appliance.

• The tableware is not properly arranged in the baskets.

Refer to basket loading leaflet.

• Make sure that the spray arms can rotate freely.

The appliance trips the cir-

cuit-beaker.

• The amperage is insufficient to supply simultaneously

all the appliances in use. Check the socket amperage

and the capacity of the meter or turn off one of the ap-

pliances in use.

• Internal electrical fault of the appliance. Contact an Au-

thorised Service Centre.

www.electrolux.com

18