Worx SAW WX527 - Инструкция по эксплуатации - Страница 13

Lithium-Ion Cordless Circular Saw EN

13

OPERATING INSTRUCTIONS

NOTE: 

Before using the tool, read the 

instruction book carefully.

INTENDED USE:

The tool is intended for ripping and cross-cutting 

wood and other materials in straight cutting lines, 

while resting firmly on the work piece.

ASSEMBLY AND OPERATION

Action 

Figure

BEFORE OPERATION

Removing the battery pack

See Fig. A1

Charging the battery

See Fig. A2

Installing the battery pack

See Fig. A3

ASSEMBLY

Saw blade Assembly and 

Removing 

WARNING: 

Always 

remove the battery 

before changing the blade!

See Fig. B

Safety On/Off Switch

WARNING:

To avoid 

cutting injury from the 

sharp blade, please  don’t put 

your hands around the Base 

Plate.

See Fig. C1, C2

Cross and Rip Cutting

Note: 

To avoid injury from 

Kickback, please don’t start 

cutting until the blade runs 

stably. 

See Fig. D1, D2

Cutting Depth Adjusting

See Fig. E1, E2

Parallel Guide

See Fig. F

Pocket Cutting

See Fig. G1, G2

Sawdust Removal

See Fig. H

WORKING HINTS FOR YOUR 

TOOL

If your power tool becomes too hot, please run your 

circular saw no load for 2-3 minutes to cool the motor. 

Avoid prolonged usage at very low speeds.

Protect saw blades against impact and shock. Cutting 

with extreme force can significantly reduces the 

performance capability of the tool and reduces the 

service life of the saw blade. Sawing performance and 

cutting quality depend essentially on the condition 

and the tooth count of the saw blade. Therefore, use 

only sharp saw blades that are suited for the material 

being cut.

Choice of blades: 24 teeth for general work, approx. 40 

teeth for finer cuts, more than 40 teeth for very fine cuts 

into delicate surfaces, diamond for tile, cement board, 

etc.

Only use saw blades recommended.

MAINTENANCE 

Remove the battery pack from the tool before 

carrying out any adjustment, servicing or 

maintenance.

Keep tools sharp and clean for better and safer 

performance. Follow instructions for lubricating and 

changing accessories. Inspect tool cords periodically and 

if damaged, have repaired by authorized service facility. 

Your power tool requires no additional lubrication or 

maintenance. There are no user serviceable parts in 

your power tool. Never use water or chemical cleaners 

to clean your power tool. Wipe clean with a dry cloth. 

Always store your power tool in a dry place. Keep the 

motor ventilation slots clean. Keep all working controls 

free of dust.

If the supply cord is damaged, it must be replaced by 

the manufacturer, its service agent or similarly qualified 

persons in order to avoid a hazard.

Periodically clear dust and chips from guard and base to 

ensure proper performance.

For Battery tools

The ambient temperature range for the use and storage 

of tool and battery is 0

o

C-45

o

C.

The recommended ambient temperature range for the 

charging system during charging is 0

o

C-40

o

C.

ENVIRONMENTAL 

PROTECTION

Waste electrical products must not be disposed 

of with household waste. Please recycle where 

facilities exist. Check with your local authorities 

or retailer for recycling

advice.