Philips PerfectCare 7000 PSG7014/10 - Инструкция по эксплуатации - Страница 8

10

Problem 

Cause 

Solution

Water leaks from the 

soleplate.

Steam condenses into water in the 

hose when you use steam for the 

first time or have not used it for a 

long time.

This is normal. Hold the iron away 

from the garment and press the 

steam trigger. Wait until steam 

instead of water comes out of the 

soleplate.

The ironing board cover 

becomes wet, or there 

are water droplets on the 

floor/garment.

Your board cover is not designed to 

cope with the high steam rate.

Use a layer of felt material in the 

board cover to prevent water 

droplets.

The surface under the base 

of the appliance becomes 

wet, or steam and/or 

water comes out from 

under the EASY DECALC 

knob.

The EASY DECALC knob is not 

tightened properly.

Switch off the appliance and wait 2 

hours for it to cool down. Unscrew 

and reattach the knob to make sure it 

is tightened.

The rubber sealing ring of the EASY 

DECALC knob is worn.

Contact an authorized Philips service 

center for a new EASY DECALC knob.

The iron does not heat up 

and the amber DECALC 

light flashes.

The appliance reminds you to 

perform the descaling procedure. 

The light flashes after approximately 

one month of use.

Perform the descaling procedure, 

following the instructions in section 

‘Descaling the appliance’.

Warranty and support

If you need information or support, please visit 

www.philips.com/support

 or read the international 

warranty leaflet.

English