Philips HI5918/20 - Инструкция по эксплуатации - Страница 6

8

Note: During the Calc-Clean process, clean water may come out of the soleplate if no scale has 

accumulated inside the iron. This is normal.

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you are 

unable to solve the problem with the information below, visit

 www.philips.com/support 

for a list of 

frequently asked questions or contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not produce 

any steam.

You have set the temperature 

dial to SYNTH to  .

Turn the temperature dial to 

   or higher.

The steam function has 

been disabled until you have 

performed the Calc-Clean 

process.

Perform the Calc-Clean process to restore the 

steam function. (see chapter 'Cleaning and 

maintenance')

At the start of your ironing 

session, the steam trigger 

has not been pressed long 

enough.

Press and hold the steam trigger until steam 

comes out. It may take up to 30 seconds until 

steam comes out.

The Calc-Clean light 

flashes. No steam comes 

out of the soleplate and/

or the appliance beeps.

You have not done or have 

not completed the Calc-Clean 

process.

Perform the Calc-Clean process to enable the 

steam function again (see chapter 'Cleaning 

and maintenance').

The appliance has 

switched off.

The auto shut-off function is 

activated automatically when 

the appliance has not been 

used for more than 5 minutes.

To activate the appliance again, set the on/

off switch to ‘off ’ position and then to ‘on’ 

position. The appliance then starts to heat up 

again.

The appliance produces a 

loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press 

the steam trigger until the pumping sound 

becomes softer and steam comes out of the 

soleplate.

Water droplets comes out 

of the soleplate.

After the Calc-Clean process 

remaining water may drip out 

of the soleplate.

Wipe the soleplate dry with a piece of cloth. 

If the Calc-Clean light still flashes and the 

appliance still beeps, perform the Calc-

Clean process (see chapter 'Cleaning and 

maintenance').

Dirty water and impurities 

(brown stains, white 

flakes, etc.) come out of 

the soleplate.

Impurities or chemicals 

present in the water have 

deposited in the steam vents 

and/or soleplate.

Performs the Calc-Clean process regularly (see 

chapter 'Cleaning and maintenance').

Water flushes out of the 

soleplate.

You have accidentally started 

the Calc-Clean process 

(see chapter 'Cleaning and 

maintenance').

Switch off the appliance. Then switch it back 

on again. Let the iron heat up until the 'iron 

ready' light lights up steadily.

English