Braun IS5145WH - Инструкция по эксплуатации - Страница 15

15

Troubleshooting guide

PROBLEM

CAUSE

REMEDY

The appliance does not 
switch on. 

The appliance is not plugged 
into a mains socket. 

Make sure the appliance is correctly 
connected and press the On/Off  
button. 

Steam comes out under the 
base unit. 

The «max» pressure safety 
system has opened. 

Turn the appliance off  immediately and 
contact an authorised Braun Customer 
Service. 

There are some water drops 
from the holes in the bottom 
of the soleplate. 

Water has condensed inside the 
tubes because steam is being 
used for the fi rst time, or has not 
been used for some time. 

Press the steam button several times 
away from the ironing board. This will 
eliminate cold water from the steam 
circuit. 

Brown coloured fl uid leaks 
from the soleplate. 

Chemical water softeners or 
additives have been poured into 
the water tank boiler. 

Never pour products into the water 
tank. Clean the sole plate with a damp 
cloth and rinse the boiler. 

The fi rst time the appliance 
is turned on, you notice 
smoke / smell. 

Some parts have been treated 
with sealer / lubricant which 
evaporates the fi rst time the iron 
heats up. 

This is normal and it will stop when you 
have used the iron a few times. 
If the smoke/smell is still present after 
turning off  the appliance, contact an 
authorised Braun Customer Service.

The appliance emits an 
intermittent noise associated 
with vibrations. 

Water is being pumped into the 
boiler. 

This is normal and no action is needed. 

Water tank is empty. 

Refi ll the water tank and press the reset 
button. 

The closure is diffi

  cult to 

unscrew. 

Lime scale has made the 
closure diffi

  cult to open. 

Turn the cap forcefully. To avoid the 
problem, rinse system frequently.

All LEDs are fl ashing. 

System error

Unplug the system, plug in again and 
press the On / Off  button. If this problem 
is still present, turn the appliance off  
immediately and contact an authorised 
Braun Customer Service. 

Steam comes out from the 
closure.

The closure is not tightened 
correctly. 

Turn off  the appliance and tighten the 
closure correctly, but not overtighten it. 

Note: 

the closure might be hot. 

The closure gasket is damaged. 

Turn off  the appliance immediately and 
contact an authorised Braun Customer 
Service.

Ironing system is ready, 
but no steam emission from 
the iron. 

End of water alarm has been 
reset without water refi ll.

Refi ll the water tank and press the 
steam button several times for 1 minute 
until pump loads water inside the 
system. 

Turn off  the appliance and wait until it 
has cooled down. 

The LED   is still on although 
water has been refi lled.

The reset button has not 
been pressed or has not been 
pressed correctly. 

Make sure the reset button is pressed 
correctly.

5712812101_CareStyle_5_INT_S6-124.indd   15

5712812101_CareStyle_5_INT_S6-124.indd   15

13.09.18   13:27

13.09.18   13:27