Timberk TAP FL70 SF - Инструкция по эксплуатации - Страница 5

www.timberk.com • electric air purifier

5

Before cleaning the device, make sure that it is unplugged. Otherwise, it may 
lead to electrical shock.
Use damp and soft cloth to wipe the external surface of the device.
To avoid electrical shock, be careful not to scratch and damage the elements 
during cleaning.
It is prohibited to use solvents, petroleum, xylene, hard brush, talcum powder 
and other substances; only water is allowed.
The device shall be cleaned once or twice in a week.
Remove dust at the top of the e2f filter using a vacuum cleaner.
Store the device in premises with low humidity.

IMPORTANT! 

Make sure to start cleaning and filter management 
after turning off power, unplugging from power outlet 
and making sure that the fan has stopped. There is 
danger for electric shock or other accidents if filter is 
changed during operation.

7. DEVICE CLEANING AND MAINTENANCE

In case of emergency contact information listed in the table 2 below. If you 
can not solve problems independently, to a service center.

8. TROUBLESHOOTING

Table 2

Breakdown

Reason

Solution

Can Not Run

1. No power
2. Did not press the On/Off bottom on 
control panel
3. Parts  of  the  electricity broken

1. Plug the power and connect well
2. Press On/Off bottom on control 
panel
3. Send to repair

Gentle air stream Cannot be off

1. Did not press the off bottom
2. Parts of the electricity broken

1.Press On/Off bottom on control panel
2. Send to repair

Abnormal Sound

1. Something inside
2. Wind wheel loose
3. Electrical machine damage

1. Remove the filter, and try again. If 
cannot settle, send to repair.
2. Send to repair
3. Send to repair

Purify function not obvious

1.Need to change filter

1. Change filter

Term reliability is 5 years.

At the end of the life of the puripier should be subjected to disposal in 
accordance the rules, regulations and methods, at the place of disposal.

9. UTILIZATION

10. TRANSPORTATION AND STORAGE

1. When transporting, any possible impacts and movements of the 
package inside a vehicle must be avoided. 

2. Handling symbols on the unit’s package must be strictly observed when 
transporting and storing it.

3.

Temperature 

requirements*

Humidity 

requirements*

Transportation and 

storage

-30°C to +50°C

15% to 85%       

(no condensate)

We are researching new technologies and constantly improving the quality 
of our products. Specifications, design and scope of delivery may be 
changed without any prior notice.

* Products must be stored in dry, ventilated storages at the temperature 
not lower than -30°C.