BRAYER BR4901 - Инструкция по эксплуатации - Страница 14

14

EN

•  It is recommended to clean the water tank (9) once a 

week. Take out the water tank (9) (pic. 13), unscrew 

the lid and rinse the tank, if there are mineral deposits 

inside the tank, fill it with a cleaning agent, wait for 

some time required to dissolve the mineral deposits, 

drain the cleaning agent, then fill the tank (9) with 

clean water and rinse it.

•  It is recommended to clean the sprayer once a week. 

Take out the removable separator (pic. 14).

•  Add some detergent drops on the sprayer and wait 

for several minutes. Remove the deposits from the 

sprayer surface with a brush (pic. 15). Wash the 

sprayer with warm water, remove the plug (10) and 

drain the water. Install the removable separator back 

to its place (pic. 14).

•  Set the water tank (9) to its place.

Note:

 you can use citric acid solution to clean the water 

tank (9), the process chamber and the sprayer.

STORAGE

•  Take the batteries out if you are not going to use the 

remote control (22) for a long time

• 

After cleaning put the air purifier away for storage 

in a dry cool place away from children and disabled 

persons.

• 

Before using the air purifier next time, it is 

recommended to check the unit operability and 

integrity of the power cord isolation and the power cord 

plug.

• 

Carry the air purifier by the handle (4).

DELIVERY SET

1. 

Air purifier with installed filters and water tank - 1 

pc.

2.  Remote control – 1 pc.

3.  Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

• 

Power supply: 220-240 V ~ 50 Hz

• 

Rated input power: 65 W

• 

Remote control:  3 V - 2 «ААА» batteries (supplied 

with the unit)

• 

Negative ion output: ≥ 10,0 mln/cm³ (in 10 cm from 

the air outlet grid)

• 

Room area: to 25 m²

• 

Productivity: 200 m³/hour