Timberk TEC.E15 DG 1500 - Инструкция по эксплуатации - Страница 7

www

.timberk.com • electric convector heater

7

Fig. 7

For models: 
TEC.E15 DG 1000
TEC.E15 DG 1500
TEC.E15 DG 2000
TEC.E15 GL 1000
TEC.E15 GL 1500
TEC.E15 GL 2000

IMPORTANT! 

In order to increase the operational life of the convector 

is recommended to note the order unit is switched off. 

Shutting down the output without pre-cooling of the 

heating elements can cause overheating and premature 

failure.

clockwise to turn off the meter. Now the thermostat will maintain the set 

temperature, periodically enabling and disabling convector. 

4. Shutdown 
4.1 Set the mode switch «OFF» and disconnect the appliance from the 

mains. 

1. Button «POWER»

Press the button «POWER», when the appliance is not working, it starts 

working by default in Low power.

2. Button «NORMAL»

Press the button «NORMAL», when the appliance is working, it starts 

working in middle power.

3. Button «X-HEAT»

Press the button «X-HEAT», when the appliance is working, it starts 

working in high power.

4. Button «ECO»

Press the button «ECO», when the appliance is working, it starts working 

in low power.

5. Button «AF»

Press the «AF» button, the light is working, the appliance would be in anti-

freeze mode. Press the button «AF» again, the appliance would be out of 

Anti-freeze mode.

6. Button «MUTE»

Press the «mute», the warning tone is off. Press the button «mute» again, 

the warning tone is on.

7. Button «X-SMART»

Press the button «X-SMART», the appliance would be on smart mode:
• When the setting temperature is higher than current temperature of 5 

degrees, it starts working in high power. 
• When the setting temperature is higher than current temperature 3 

degrees or the setting temperature is lower than current temperature 5 

degrees, it starts working in middle power. 
• When the setting temperature is lower than current temperature 3 

degrees, it starts working in low power.

8. Button «LIGHT»

Press the button «LIGHT», the appliance would be on night mode. The light 

display, display screen will turn off.
Press the button «LIGHT» again, the appliance would be out of night mode.

9. Button «UP» and «DOWN»

• Press the button «UP» or «DOWN», it would increase or decrease the 

temperature settings (default settings are 25 degrees). 
• When set a temperature or timer, if no any setting action in 3 seconds, 

the timer would be confirmed. 

2

4

14

15

16

17

18

19

1

9

13

6
7
8

3

5

10

11