Soler & Palau PM-755 - Инструкция по эксплуатации - Страница 5

ENGLISH

13

8.  Do not install the device immediately underneath a power soc-

ket.

9.  For fixed electrical installation, disconnection means should 

be included in accordance with installation regulations, with 

contact separation at all poles that provides total disconnec-

tion under Category III overvoltage conditions.

10. This heater is Class II (double-insulated ) and therefore does 

not require an earth connection.

11. The safety zones required by the local electrical installation 

standards or safety regulations applicable in your country must 

be strictly observed. In any case, if it is going to be installed in 

a bathroom, NEVER install it in the area indicated as AREA 0, 

AREA 1 or AREA 2. As it is an IP21 rated device, it can be ins-

talled in AREA 3, provided it is placed so that it is NOT in reach 

of anybody who is in the bathtub or shower, this including the 

device’s power cord. (See FIGURE 3).

12. 

 CAUTION: Some parts of this device may get very hot and 

cause severe burns. Special care must be taken when children 

and vulnerable persons are present.

13. Before plugging in the device, make sure the mains voltage 

matches that indicated on the data plate.

14. If the power cord is damaged, it should be replaced at one of 

our official S&P Service Centers or by a qualified professional.

15. 

 To avoid overheating, DO NOT COVER the device.

16. Do not insert any rigid body through the bars, this could dama-

ge the device, start a fire or cause electric shock.

17. In humid rooms, the power cord must be at least 25 cm above 

the ground. Make sure the cord doesn’t touch the ground.

18. Make sure the power cord doesn’t touch the hottest parts of 

the device.

19. Children under 3 years old should be kept out of the reach of 

the appliance unless they are continuously supervised.

20. Children under 8 years old may NOT operate the appliance.