Omron Comp Air NE-C21 basic - Инструкция по эксплуатации - Страница 13

EN

13

Care and maintenance

Cleaning and disinfecting

  Caution: Handling the Vaporizer Head

• 

Always wash the vaporizer head after each use.

• 

Do not use a brush or pin to clean the vaporizer head.

• 

When disinfecting the parts by boiling, be sure to boil them in plenty of water.

• 

Do not boil vaporizer head together with objects other than applicable nebulizer 

accessories.

Cleaning

Clean the parts after each use to remove residual medication. This will avoid inefficient 

nebulization or infection.

■

Washable parts

• 

Nebulizer Kit (Inhalation top, Medication tank), Mask (PVC)/(SEBS), Mouthpiece, 

Nosepiece

Wash them in warm water and mild detergent (neutral detergent). Rinse them 

thoroughly with clean hot tap water and allow to air dry in a clean place.

• 

Vaporizer Head

Wash it with running water.

■

Non-washable parts

• 

Compressor, Air Tube

Firstly, make sure that the power plug is unplugged from the power outlet. Wipe clean 

with a soft cloth moistened with water or mild detergent (neutral detergent).

• 

Air Filter

Do not wash or clean the air filter. If the air filter becomes wet, replace it. Damp air 

filters can cause blockages.

Disinfecting

Disinfect the parts once a week. If the parts are heavily stained, replace them with new 

ones.

To select a method for disinfection, refer to the table on page 14.

9. 

Hold the nebulizer kit as indicated on the right.
Follow the instructions of your doctor or respiratory 

therapist. Exhale as normal through mouthpiece, 

mask or through the nose.

Caution:

Do not tilt the nebulizer kit at an angle of greater than 45 

degrees in all directions. Medication may flow into the 

mouth or it may result in not nebulizing effectively. 

10. 

Press the power switch to the on (   ) position. As the compressor starts, 

nebulization begins and aerosol is generated. 

Inhale the medication.

11. 

When treatment is complete, turn the power off. Unplug the AC adapter from the 
power outlet and disconnect it from the compressor.

Note:

Securely hold and press the power plug down 

to disconnect the AC adapter.

Caution:

Do not pull the power cord. 

Damage may be caused. 

Right angle

45°

45°

Compressor

Power plug