Karcher BP 3 1.645-365 - Инструкция по эксплуатации - Страница 11

– 2

With a permanent installation the pump can be screwed 
onto a suitable surface.



Use suitable screws to screw the bases onto a level 
surface.

In case of a permanent installation the installation of a 
flexible component such as a flexible pressure compen-
sating hose (see optional accessories) on the pressure 
side is recommended. This has the following benefits:



More flexibility during set-up and installation.



Noise reduction, since no vibrations are transferred 
to pipes.



In case of small leaks, the pump does not switch as 
often.

Note

To facilitate subsequent emptying and pressure release 
of the system, we recommend the installation of a stop-
cock between pump and pressure line.
(not included in delivery)
By closing the shut-off valve when emptying the pump 
you can prevent water from escaping from the pressure 
line.



Insert the mains plug into the socket. 



Switch the appliance on at the appliance switch.

몇

Caution

Pump starts running immediately. Wait till the pump 
sucks in and pumps uniformly, then shut the gate valve 
in the pressure pipe. The pressure switch deactivates 
the motor when the shut-off pressure is reached.  The 
storage boiler is now full; the domestic water supply sys-
tem is ready for operation.
If there is a lack of supplied water, the switch-off pres-
sure is not reached; the pressure switch cannot shut off 
the appliance. The water in the pump head will then 
heat up. 
In case of overheating, the power supply is interrupted 
by a thermal switch, to avoid damage to the pump from 
overheating.
The supply of power is switched back on after the appli-
ance has cooled off.
We recommend installing a dry run protection unit to 
regulate the lack of water situation (see special acces-
sories).

Caution

System is under pressure!
(For pressure details see chapter on technical specifica-
tions)



Switch the appliance off at the power switch.



Disconnect the main plug from the socket.



DANGER

Turn off the appliance and remove the mains plug prior 
to any care and maintenance works.

Open the connected shutoff valves to relief pressure 
and reclose them. The system is free of pressure.



Rinse the pump after every use if you use to trans-
port water with additives.



Check the pressure of the air filling in the storage 
boiler every six months. If necessary, refill up to 2.0 
bar in switched off / zero-pressure state (discon-
nect device, open the water cock).

Illustration 
The air valve is located under the cover. Turn in anti-
clockwise direction to unscrew the cover.

몇

CAUTION

In order to prevent accidents or injuries, keep in mind 
the weight of the appliance during transport (see Spec-
ifications).



Lift appliance by the carrying handle and carry it.



Secure the appliance against shifting and tipping 
over.

몇

CAUTION

In order to prevent accidents or injuries, keep in mind 
the weight of the appliance when selecting a storage lo-
cation for it (see Specifications).



Fully drain the appliance prior to storing it.



Store the appliance in a frost free area.

Permanent installation

Operation

Finish operation

Maintenance and Care

Care

Maintenance

Transport

When transporting by hand

When transporting in vehicles

Storage

Storing the Appliance

11

EN