Karcher BP 3 1.645-365 - Инструкция по эксплуатации - Страница 10

– 1

Dear Customer.

Please read and comply with these origi-
nal operating instructions and the en-
closed safety instructions. Proceed ac-

cordingly. Keep both booklets for future reference or 
subsequent owners.

This appliance has been designed for use in private 
households and is not intended for commercial use. 
The manufacturer is not responsible for any damages 
that may occur on account of improper use or wrong op-
erations.
The device is meant for use as house water tank. 
This unit is only to be used indoors.

Note

The pump is not suited for increasing the existing line 
pressure.



Used water



Well water



Water source



Rain water



Water from swimming pool (provided the dosing of 
additives is proper)

The packaging material can be recycled. 
Please do not place the packaging into the or-
dinary refuse for disposal, but arrange for the 

proper recycling.

Old appliances contain valuable materials that 
can be recycled. Please arrange for the proper 
recycling of old appliances. Please dispose 
your old appliances using appropriate collec-

tion systems.

Notes about the ingredients (REACH)

You will find current information about the ingredients 
at: 

www.kaercher.com/REACH

The warranty terms published by the relevant sales 
company are applicable in each country. We will repair 
potential failures of your appliance within the warranty 
period free of charge, provided that such failure is 
caused by faulty material or defects in manufacturing. In 
the event of a warranty claim please contact your dealer 
or the nearest authorized Customer Service centre. 
Please submit the proof of purchase.

Illustration 
1

Backflow valve

2

Connection adapter for pumps G1

3

Stopper

4

Connection G1(33.3mm) Suction pipe

5

Filling nozzle

6

Connection G1(33.3mm) Pressure pipe

7

Carrying handle

8

Power switch

9

Air valve (Schrader valve) with cap

10 Base with slotted hole for bolted connection
11 Pressure display
12 Drain screw
13 Power cord with plug



Check max. air pressure in the storage tank prior to 
commissioning. If necessary, refill up to 2.0 bar 
with a commercially available air pump with the 
system switched off / zero-pressure state.



Secure device against slipping off (fix it with 
screws, if needed). 



Remove the plug.



Screw the connection adapter in the suction con-
nection of the pump (inlet).
Tighten manually.



Screw check valve onto connector adapter at the 
suction connection.
Tighten manually.



Connect the vacuum-proof suction hose with inte-
grated backflow stop on the suction side. 
(available as optional accessory)



Screw the connection adapter in the delivery con-
nection of the pump (outlet).
Tighten manually.



Connect delivery line.

Illustration 



Unscrew the lid of the filling nozzle and fill in water 
till it overflows.



Screw on the lid on the filling nozzle.



Open existing shutoff valves in the pressure pipe.

Note

Even the smallest of leakage leads to malfunctioning.



In case of leaks, seal all connections with a suitable 
sealant (e.g. Teflon tape) to prevent malfunction 
due to leakage or air intake.

Contents

Contents

EN

1

General information

EN

1

Operation

EN

1

Maintenance and Care

EN

2

Transport

EN

2

Storage

EN

2

Special accessories

EN

3

Troubleshooting

EN

4

Technical specifications

EN

5

General information

Proper use

Approved fluids

Environmental protection

Warranty

Operation

Description of the Appliance

Preparing the Appliance

10

EN