Lavor PRO HYPER C 1211 LP RA 8.654.0086 - Инструкция по эксплуатации - Страница 19

                       (if fitted) 

IMPORTANT:

This water cleaner is equipped 

with the A.S.S. (Automatic Stop System), which 

stops the machine during the bypass phase. 

To start the water cleaner, it is therefore necessary 

to set the switch on position “ON”; after that 

press the pistol trigger: the Automatic Stop 

System will start the machine and will stop it 

automatically when the trigger is released. It 

is advisable to put on the safety of the pistol 

trigger whenever the machine is stopped, in 

order to avoid unintentional starting.

•  Any automatic start of the machine without 

pressing the gun trigger is attributable to 

air bubbles in the water or other similar 

phenomena which do not imply the existence 

of any defects in the machine. 

•  Do not leave the appliance unattended during 

the standby for more than 5 minutes. Contrarily, 

for the safety of the appliance it is necessary to 

re-turn the switch into the OFF position.

•  Please check that the coupling of the high 

pressure hose with the appliance and the 

gun supplied as standard equipments made 

correctly, that is to say without any water leak.

If the appliance is equipped with a pressure 

regulator:

•  when the pressure is set to minimum the A.S.S. 

may not trigger. Therefore, do not allow the 

appliance to function in by-pass for more than 

1 minute.

•  do not act on the gun lever too frequently (this 

may cause a malfunction).

>     APPLIANCES PROVIDED WITH THERMAL 

VALVE (OPTIONAL)

This device enables the machine’s by-pass op-

eration through automatic water discharge 

whenever it reaches a temperature of nearly 

60°C and cooling working components.

•

CAUTION:  appliances that are not provided 

with this disposal must not operate for more 

than 2 minutes with released gun. Recycled 

water raises its temperature remarkably 

causing great damages to the pump.

>  INSTALLATION AND START-UP

> INSTALLATION

•  Check that the master switch is turned to 

“OFF” and that the water filter is fitted into 

the pump’s inlet pipe.

•  Screw the snap connection into place by hand, 

without the aid of tools.

•  Connect the water supply hose to the snap 

connection. The hose must have an inside 

diameter of at least 13 mm (1/2”).

•  Connect the high pressure hose to the pump’s 

outlet pipe. Press the high pressure hose 

coupling fully down and then screw into place 

by hand without the aid of tools.

•  Connect the high pressure hose to the gun.

(fig. 

B

)

• Turn the water tap fully on. The water 

temperature absolutely must be below 40°C.

IMPORTANT: The washer machine has to 

operate with clean water in order to avoid any 

damages to the washer machine itself.

•  Release the gun safety catch and keep the 

trigger pressed, allowing the water to flow until 

all the air has been expelled.

•  Fit the lance into the gun.

•  Fit the nozzle  into the lance.

•  Connect the plug to the power socket.

>  1ST START-UP

When starting up for the first time or after a long pe-

riod out of use, connect the intake line only for a few 

minutes so that any dirt is vented from the delivery 

outlet 

> START-UP

(fig. 

C

)

•  Whenever using the high-pressure cleaner, users are 

urged to hold the gun in the correct position, with one 

hand on the grip and the other on the spray rod.

•  To start the machine, press the gun trigger 

and at the same time turn the master switch to 

“ON”

EN

19