Мойки высокого давления Karcher HDS 650 4M BASIC - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
-
8
Figure 12
Î
Ready a catch bin for appr. 1 Liter oil.
Î
loosen release screw.
Î
Tighten release screw.
Î
Fill oil slowly up to the MAX marking.
Note:
Air pockets must be able to leak out.
For oil type refer to technical specifications.
Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
–
Fuel tank empty
Î
Refill.
–
Engine overload/overheat
Î
Turn device switch on "0" and let engine
cool off for min. 5 minutes.
Î
If malfunction still occurs, have device
checked by customer service.
Î
No line voltage, see "Appliance is not
running".
–
Liquid softener tank is empty, due to
technical reasons a remainder stays in
the tank.
Î
Refill.
–
Electrodes in the tank are dirty
Î
Clean the electrodes.
Î
Set the appliance switch to "0".
Î
Allow device to cool down.
Î
Set the appliance switch to "I".
–
No power
Î
Check power connection/conduit.
–
Air within the system
Vent pump:
Î
Set dosing value for detergent to "0".
Î
With open hand spray gun turn device
on and off multiple times with the device
switch.
Î
Close and open the regulating spingle
(figure 7) with open hand spray gun.
Note:
By dismantling the high pressure
hose from the high pressure connection the
venting process is accelerated.
Î
If detergent tank is empty, refill.
Î
Check connections and conduits.
–
Pressure is set to MIN
Î
Set pressure to MAX.
–
Sieve in the water connection is dirty
Î
Clean sieve.
Î
Clean the fine filter; replace it, if necessary.
–
Amount of water supply is too low.
Î
Check water supply level (refer to tech-
nical data).
–
Pump leaky
Note:
3 drops/minute are allowed.
Î
With stronger leak, have device
checked by customer service.
–
Leak in the high pressure system
Î
Check high pressure system and con-
nections for tightness.
Oil change.
Dispose of old oil ecologically or turn in at
a gathering point.
Troubleshooting
Fuel indicator lamp glows
Indicator lamp "Ready for use"
turns off
Indicator lamp liquid softener glows
Engine control lamp glows
Appliance is not running
Device is not building up pressure
Device leaks, water drips from the
bottom of the device.
Device turns on and off while hand
spray gun is closed
24
EN
