Karcher HD 1000 SI - Инструкция по эксплуатации - Страница 7

English

– 1

Please read and comply with 
these safety instructions prior 

to the initial operation of your appliance. 
Retain these safety instructions for use for 
future reference or for subsequent posses-
sors.

–

Please read the operating instructions 
for your machine before using it, and 
pay particular attention to the following 
safety instructions.

–

Warning and information plates on the 
machine provide important directions 
for safe operation.

–

Apart from the notes contained herein 
the general safety provisions and rules 
for the prevention of accidents of the 
legislator must be observed.

–

The voltage indicated on the type plate 
must correspond to the voltage of the 
electrical source.

–

Minimum fuse strength of the socket 
(see Technical Data).

–

Safety class I - Appliances may only be 
connected to sockets with proper earth-
ing. 

–

It is recommended that you connect this 
device to a socket that has a 30 mA pro-
tection switch against wrong currents.

–

Please use the mains cable prescribed 
by the manufacturer; the same is also 
applicable when you replace the ca-
bles. See Operating Instructions Manu-
al for Order Number and Type.

–

Check the power cord with mains plug 
for damage before every use. If the 
power cord is damaged, please arrange 
immediately for the exchange by an au-
thorized customer service or a skilled 
electrician.

–

The appliance may only be connected 
to an electrical supply which has been 
installed by an electrician in accordance 
with IEC 60364.

–

Operating procedures create short term 
power sinkings.

–

During unfavorable net conditions other 
devices might be disturbed.

–

With a net impedance lower then 0,15 
Ohm no disturbances are to be expect-
ed.

–

Never touch the mains plug with wet 
hands.

–

Make sure that the power cord or exten-
sion cables are not damaged by run-
ning over, pinching, dragging or similar. 
Protect the cable from heat, oil, and 
sharp edges.

–

The extension cable must have the 
cross-section listed in the circuit plan 
and be protected against spraying wa-
ter. The connection must not lie in wa-
ter.

–

The plug and coupling of the extension 
cable used must be spray watertight.

–

Unsuitable extension cables can be 
hazardous. Only use extension cables 
outdoors which have been approved for 
this purpose and labelled with a suffi-
cient cable cross-section.

–

The power cord must be checked regu-
larly for damages, such as cracks or ag-
ing. If damage is found, the cable must 
be replaced before further use.

–

If couplings of the power cord or exten-
sion cable are replace the splash pro-
tection and the mechanical tightness 
must be ensured.

–

Do not clean the appliance with a water 
hose or high-pressure water jet (danger 
of short circuits or other damage).

–

Do not operate the appliance at temper-
atures below 0 °C.

–

Please observe the safety instructions 
of your water supply authority.

–

Please ensure that screw connections 
of all hoses are not leaky.

Safety Instructions for High Pressure Cleaners

Power connection

Water connection

7

EN