Bosch EasyAquatak 100 Long Lance 06008A7E01 - Инструкция по эксплуатации - Страница 19

English | 

19

Problem

Possible Cause

Corrective Action

Voltage loss due to use of extension cable

Check characteristics of extension cable

Appliance not used for a long period of time

Contact your Bosch Service Centre

Problems with TSS (Total Stop System) device

Contact your Bosch Service Centre

Pressure pulsating

Air in the inlet water supply hose/pump

Allow pressure washer to run with open spray
handle and nozzle at low pressure until regular
working pressure is obtained

Inadequate water supply

Check that the water supply corresponds to spe-
cifications. The minimum specification for the wa-
ter supply hose is 1/2" or 13 mm diameter

Water filter blocked

Clean water filter

Water supply hoses squeezed

Straighten out kinked water supply hoses

High pressure hose too long

Remove high pressure extension hose. Retry (ex-
tension hose max. 7 m)

Pressure too low, but
steady
Note: Several types of
accessory will normally
deliver a lower pres-
sure

Nozzle worn

Change the nozzle

Start/stop valve worn

Activate trigger five times in quick succession

Motor starts up but
with restricted or no
working pressure

No water supply

Connect water supply

Water filter clogged up

Clean the water filter

Nozzle clogged up

Clean nozzle

The pressure washer
starts irregularly by it-
self

Pump/ power gun leaky

Contact your Bosch Service Centre

Water leaks from ma-
chine

Leaking pump

A slight water leak is permissible; in case of ex-
cessive leak, contact Bosch Service Centre.

Maintenance and Service

Maintenance

u

Stop, remove plug from the power supply and discon-
nect from water supply.

Note:

 To ensure long and reliable service, carry out the fol-

lowing maintenance regularly.
Regularly check for obvious defects such as loose fixings,
and worn or damaged components.
Check that covers and guards are undamaged and correctly
fitted. Carry out necessary maintenance or repairs before
using.
In order to avoid safety hazards, if the power supply cord
needs to be replaced, this must be done by 

Bosch

 or by an

after-sales service centre that is authorised to repair 

Bosch

power tools.

After use/Storage

Turn the main switch off and operate the trigger to drain the
water from the high pressure hose.
Clean the exterior of the machine thoroughly using a soft
brush or cloth. Do not use water, solvents or polishes. Re-
move all debris, especially from the ventilation slots.

End of season storage: Drain water out of pump running mo-
tor for a few seconds. Pull trigger to release all water.
Do not place other objects on top of the machine.
Store in a frost-free area.
Ensure cables are not trapped when storing. Do not kink high
pressure hose.

Environmental Protection

Chemicals dangerous to the environment must not be al-
lowed to enter the ground, ground water or ponds, streams,
etc.
For the use of cleaning agents, observe the instructions on
the package and the prescribed concentration exactly.
For the cleaning of motor vehicles the local regulations
should be observed: Do not allow oil sprayed off to enter into
the ground water. Recycle raw materials instead of waste
disposal.

After-sales Service and Application
Service

www.bosch-do-it.com

Bosch Power Tools

F 016 L94 016 | (17.01.2020)