Bosch EasyAquatak 100 Long Lance 06008A7E01 - Инструкция по эксплуатации - Страница 12

12

 | English

nales Recht mu

̈

ssen nicht mehr gebrauchsfa

̈

hige Elektro-

werkzeuge getrennt gesammelt und einer umweltgerechten
Wiederverwertung zugefu

̈

hrt werden.

English

Safety Notes

Explanation of symbols

General hazard safety alert.

Never direct the water jet at
people, animals, the machine

or electric components. 
Warning: High pressure jets can be
dangerous if subject to misuse.

According to the applicable
regulations, the appliance
must never be used on the

drinking water network without a
system separator. Use a separator
as per IEC 61770 Type BA.

Water flowing though a system sep-
arator is considered not drinkable.

Safety Notes for pressure washer

Read all safety warnings
and all instructions.

 Failure

to follow the safety warnings

and instructions may result in electric
shock, fire and/or serious injury.

The warning and information signs
attached to the unit provide import-
ant information for safe operation.
Apart from the information in the
operating instructions comply with

the general safety regulations and
regulations for the prevention of ac-
cidents.

Connecting to the mains

u

The voltage of the power source
must correspond with the data on
the type plate of the product.

u

We recommend that this product is
only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA resid-
ual current.

u

The circuit breaker supplying mains
power to the high-pressure washer
should have no less than a C16 rat-
ing. If in doubt consult a qualified
electrician for further advice. Do not
attempt to modify your electrical
system yourself.

u

Remove the plug from socket
whenever the machine is left unat-
tended for any period.

u

The electric supply installation
should comply with IEC 60364-1.

u

If the supply cord is damaged, it
must be replaced by the manufac-
turer, its service agent or similarly
qualified persons in order to avoid a
hazard.

u

If the plug is damaged, pay attention
to the following:

u

Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide
adequate protection against ingress
of water, etc. and cable entries re-

F 016 L94 016 | (17.01.2020)

Bosch Power Tools