Bosch AdvancedAquatak 150 - Инструкция по эксплуатации - Страница 18

18

 | English

F 016 L81 291 | (20.07.2018)

Bosch Power Tools

Do not kink or drive a motor vehicle over the high pressure
hose. Do not expose the high pressure hose to sharp edges
or corners.

Working advice for cleaning with detergents

u

Only use cleaning agents suitable specifically for high
pressure washers.

We recommend that you use detergent sparingly for the sake
of the environment. Observe the recommended dilution on
the detergent label.

Recommended cleaning method

Step 1:

 Attach the fixed fan nozzle and remove the heavy

dirt.

Step 2:

 Attach the foam bottle and spray on the detergent

sparingly.

Step 3:

 Rinse off the loosened dirt and detergent with the

fan nozzle.

Note:

 When cleaning a vertical surface spray off dirt/deter-

gent from the bottom and work in an upwards direction.
Rinse from the top and work downwards.

Use with alternative water sources

This high-pressure washer will self prime and can draw water
from water tanks and natural water sources. It is 

IMPORT-

ANT

 that the water is clean and the BOSCH inlet filter is clear

and fitted to the machine.

Open tanks/containers and natural water
sources

Use the Self Priming accessory kit comprising:
– Inlet strainer with non return valve
– 3 m reinforced supply hose
– Universal coupling to the pressure washer
This enables the pressure washer to draw water up to 0.5 m
above the water level in the source. This may take up to 15
seconds.
Submerge the 3 m hose in water to displace the air. Connect
the 3 m supply hose to the pressure washer ensuring that
the inlet strainer remains submerged in the water source.
Run the pressure washer with the lance disconnected until a
steady flow of water appears from the high pressure hose.
Stop if this has not been achieved within 25  seconds and
check all the connections. Switch off and connect the lance
and nozzle to operate.
It is important to ensure that all hose and coupling connec-
tions are of good quality, air tight and that all washers are in
good condition and correctly seated in place. Failure to do
so may affect the self priming performance.

Water Tanks with outlet connections

When connecting the pressure washer to a water tank with a
suitable tap outlet, first connect the supply hose (not
provided) to the tank outlet, open the tap to allow the water
to displace all the air in the hose and then connect to the
pressure washer.

Troubleshooting

Problem

Possible Cause

Corrective Action

Motor refuses to start

Plug not connected

Connect plug

Mains socket faulty

Use another socket

Fuse faulty / blown

Replace fuse

Extension cable damaged

Try without extension cable

Motor protector has activated

Allow to cool for 15 minutes

Frozen

Wait for pump/water supply hose/accessory to
thaw

Motor stops

Fuse faulty / blown

Replace fuse

Wrong mains voltage

Check that mains voltage corresponds to specific-
ations on the model tag

Motor protector has activated

Allow to cool for 15 minutes

Fuses blow

Fuses incorrectly rated

Change to a mains supply higher than the pres-
sure washer amp consumption

Motor starts but no
pressure

Nozzle partly blocked

Clean nozzle

Motor “sounds” but
fails to start

Insufficient power supply

Check that the voltage of the mains power supply
line is the same as that on the plate.

Voltage loss due to use of extension cable

Check characteristics of extension cable

Appliance not used for a long period of time

Contact your Bosch Service Centre