Bosch AdvancedAquatak 150 - Инструкция по эксплуатации - Страница 12

12

 | English

F 016 L81 291 | (20.07.2018)

Bosch Power Tools

Never direct the water jet at
people, animals, the machine

or electric components. 
Warning: High pressure jets can be
dangerous if subject to misuse.

According to the applicable
regulations, the appliance
must never be used on the

drinking water network without a
system separator. Use a separator
as per IEC 61770 Type BA.

Water flowing though a system sep-
arator is considered not drinkable.

≥100 A

The 

Advanced

Aquatak 150 is

intended for use only in
premises having a service cur-

rent capacity ≥100 A per phase, sup-
plied from a distribution network hav-
ing a nominal voltage of 230 V. If in
doubt please contact your Supply Au-
thority.

Safety Notes for pressure washer

Read all safety warnings
and all instructions.

 Failure

to follow the safety warnings

and instructions may result in electric
shock, fire and/or serious injury.

The warning and information signs
attached to the unit provide import-
ant information for safe operation.
Apart from the information in the
operating instructions comply with
the general safety regulations and
regulations for the prevention of ac-
cidents.

Connecting to the mains

u

The voltage indicated on the rating
plate must correspond to the voltage
of the power source.

u

We recommend that this equipment
is only connected into a socket
which is protected by a circuit-
breaker that would be actuated by a
30 mA residual current.

u

The circuit breaker supplying mains
power to the high-pressure washer
should have no less than a C16 rat-
ing. If in doubt consult a qualified
electrician for further advice. Do not
attempt to modify your electrical
system yourself.

u

Remove the plug from socket
whenever the machine is left unat-
tended for any period.

u

The electric supply installation
should comply with IEC 60364-1.

u

If the supply cord is damaged, it
must be replaced by the manufac-
turer, its service agent or similarly
qualified persons in order to avoid a
hazard.

u

If the plug is damaged, pay attention
to the following:

u

Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide
adequate protection against ingress
of water, etc. and cable entries re-
quire effective sealing. Rubber
shrouds should be provided over
cable glands. Drip-proof (class IP X2
of BS 5490) plugs and sockets to BS