Bosch 0600910500 - Инструкция по эксплуатации - Страница 12

12 | English 

1 609 92A 3EV | (16.5.17)

Bosch Power Tools



The unit must not be operated by chil-

dren or juveniles. Children should be 

supervised to ensure that they do not 

play with the unit.



The unit may only be used by author-

ised persons who have received 

training or have demonstrated their 

ability to operate the unit.

Wear personal protective 

equipment (PPE) e. g. safety 

goggles, dust mask etc. to pro-

tect against water, particles and/or aer-

osols sprayed back from parts. Do not 

inhale aerosols if self-priming from ex-

ternal sources. Such water can contain 

disease-causing agents.



Do not use the appliance within the 

range of persons unless they also 

wear protective clothing.

Connecting to the mains



The voltage indicated on the rating 

plate must correspond to the voltage 

of the power source.



The operating voltage is 230 V AC, 

(for non-European countries 220 V or 

240 V, as applicable).



This is a class 

I

 unit and may only be 

connected to properly earthed power 

sources.



The electric supply installation shall 

be made by a qualified electrician and 

comply with IEC 60364-1. 



We recommend that this equipment 

is only connected into a socket which 

is protected by a circuit-breaker that 

would be actuated by a 30 mA residu-

al current.

Requirements for extension cords 

and plugs



Warning: Inadequate extension cords 

can be dangerous. The extension 

cord must have an earth wire. Exten-

sion cord, plug and socket must be of 

waterproof construction, protected 

against splashed water and intended 

for outdoor use. If in doubt, contact a 

qualified electrician or the nearest 

Bosch Service Centre.



The following wire dimensions are 

recommended: Up to 20 m length, 

2.5 mm

2

 wire diameter, up to 50 m 

length 4.0 mm

2

 wire diameter.



If your plug is not suitable for your 

socket outlets, it should be cut off 

and an appropriate plug fitted in its 

place by an authorized customer ser-

vice agent. In case of electric plug 

with internal fuse, the replacement 

plug should have the same fuse rat-

ings as the original plug. The severed 

plug must be disposed of to avoid a 

possible shock hazard and should 

never be inserted into a mains socket 

elsewhere.



Products sold in GB only: Your prod-

uct is fitted with an BS 1363/A ap-

proved electric plug with internal fuse 

(ASTA approved to BS 1362).



Remove the plug from socket when-

ever the machine is left unattended 

for any period.



Do not touch the plug or socket with 

wet hands.



Do not pull plug while operating the 

device.

OBJ_BUCH-2319-004.book  Page 12  Tuesday, May 16, 2017  11:15 AM