ADA GroundDrill-10 - Инструкция по эксплуатации - Страница 6

6

English

lead to the breakage of the gear-wheel of the gear case and the parts of 

the engine. Slow down the engine and disconnect it from the auger bit. Set 

the pivot of appropriate diameter into the hole of pin – release the auger 

bit turning it back.

1. Let engine warm for at least 1 min.

2. Press or release throttle lever to get desired rpms. If the engine reduce 

rpms on load, adjust the position of throttle lever.

Important! 

Do not work without workmate. Otherwise it can lead to the 

damages. Avoid running at high rpms for long periods. The unit needs time 

for lubricant to get to all internal parts. Do not run the motor at high rpms 

without load. 

STOPPING

1. Release throttle to idle speed.

2. Turn the ignition switch OFF.

Note: 

When storing for long periods, remove all fuel from the gas tank. Do 

not leave the gas tank at an angle. The pressure inside the tank can cause 

the gas to spill out. The gas can spill out on the hot parts of the engine. it 

can lead to the flame development. 

AIR FILTER

The air filter must be free of dust and dirt to avoid:

1. Carburettor problems

2. Startup problems

3. Reduced engine power

4. Excessive wear of engine parts

5.Abnormal  fuel  consumption.  Clean  the  air  filter  daily,  or  more  often 

when working in a dusty area.

AIR FILTER CLEANING

Remove the air filter cover and filter.Wash it in warm soap solution. Before 

reassembling, check that the filter is dry and not damaged. If the filter has 

damages, it’s necessary to replace it. The air filter may not be completely 

cleaned when washing and drying. Therefore, it should be regularly re-

placed with a new one.

SPARK PLUG

The condition of the spark plug is affected by: