GIGABYTE GA MA790XT UD4P - Инструкция по эксплуатации - Страница 49

- 49 -

BIOS Setup

Link Detected

Displays transmission speed

Cable Length

Displays the approximate length of the attached LAN cable.

Start detecting at Port.....
Link Detected --> 100Mbps
Cable Length= 3 0 m

Note: The Gigabit hub will only operate at a speed of 10/100Mbps in MS-DOS mode; it will operate
at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is
activated.

When a Cable Problem Occurs...

If a cable problem occurs on a specified pair of wires, the Status  field will show Short  and
thenlength shown will be the approximate distance to the fault or short.
Example: 

P a r t 1 - 2   S t a t u s   =   S h o r t   /   L e n g t h     =     2 m

Explanation: A fault or short might occur at about 2m on Part 1-2.

Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Status fields will
show  Open, and the length shown is the approximate length of the attached LAN cable.

When LAN Cable Is Functioning Normally...

If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub,
the following message will appear:

Onboard 1394 Function

Enables or disables the onboard IEEE 1394 function. (Default: Enabled)

OnChip USB Controller

Enables or disables the integrated USB 1.1 controller. (Default: Enabled)

USB EHCI Controller

Enables or disables the integrated USB 2.0 controller. (Default: Enabled)

USB Keyboard Support

Allows USB keyboard to be used in MS-DOS. (Default: Enabled)

USB Mouse Support

Allows USB mouse to be used in MS-DOS. (Default: Disabled)

Legacy USB storage detect

Determines whether to detect USB storage devices, including USB flash drives and USB hard
drives during the POST. (Default: Enabled)

Onboard Serial Port 1

Enables or disables the first serial port and specifies its base I/O address and corresponding
interrupt. Options are: Auto, 2F8/IRQ3, 3F8/IRQ4(default), 3E8/IRQ4, 2E8/IRQ3, Disabled.