Philips QT4019 - Инструкция по эксплуатации - Страница 2

Introduction

Congratulations on your purchase and welcome to 

Philips! To fully benefit from the suppor t that Philips offers, 

register your product at www.philips.com/welcome.

General description (Fig. 1)

A

  Beard trimming comb

B

  Cutting unit

C

  Precision Zoom Lock 

`

 adjustment ring 

D

  Charging light

E

  Socket for appliance plug 

F

  On/off slide

G

  Adapter

H

  Appliance plug

I

  Cleaning brush

Important

Read this user manual carefully before you use the 

appliance and save it for future reference.

Danger

 - Make sure the adapter does not get wet. 

Warning

 - The adapter contains a transformer. Do not cut 

off the adapter to replace it with another plug, as 

this causes a hazardous situation.

 - This appliance is not intended for use by persons 

(including children) with reduced physical, sensor y 

or mental capabilities, or lack of experience and 

knowledge, unless they have been given super vision 

or instruction concerning use of the appliance by a 

person responsible for their safety.

 - Children should be super vised to ensure that they 

do not play with the appliance.

Caution

 - Use, charge and store the appliance at a temperature 

between 5°C and 35°C.

 - Only use the adapter supplied.

 - Never immerse the appliance in water or rinse it 

under the tap. 

 - If the adapter is damaged, always have it replaced 

with one of the original type in order to avoid a 

hazard.

 - This appliance is only intended for trimming the 

human beard. Do not use it for any other purpose.

 - Do not use the appliance if the cutting unit or the 

beard trimming comb is damaged or broken, as this 

may cause injur y.

 - Noise level: Lc = 64 dB(A).

Electromagnetic fields

This Philips appliance complies with all standards 

regarding electromagnetic fields (EMF). If handled 

properly and according to the instructions in this user 

manual, the appliance is safe to use based on scientific 

evidence available today.

General

 - The appliance is equipped with an automatic voltage 

selector and is suitable for mains voltages from 100 

to 240 volts.

 - The adapter transforms 100-240 volts to a safe low 

voltage of less than 24 volts.

Charging

Charge the appliance fully before you use it for the first 

time.

It takes approximately 10 hours to fully charge the 

appliance.

When it is fully charged, the appliance has a cordless 

operating time of up to 35 minutes.

Note: You can use the appliance cordless  as well as 

connected to the mains.

  1 

  Make sure the appliance is switched off (Fig. 2).

  2 

  Insert the appliance plug into the appliance (Fig. 3).

  3 

  Put the adapter in the wall socket.

,

The charging light on the appliance goes on to 

indicate that the appliance is charging. 

Note: The charging light does not change colour and does 

not go out when the appliance is fully charged.

  4 

  After charging, remove the adapter from the 

wall socket and pull the appliance plug out of the 

appliance. 

Optimising the lifetime of the rechargeable 

battery

When you have charged the appliance for the first time, 

we advise you to use it until the batter y is completely 

empty.

Do not recharge the appliance in between the trimming 

sessions.

Continue to use the appliance until the motor almost 

stops running during a session. Then recharge the batter y. 

Follow this procedure at least twice a year.

Trimming

Always comb the beard and/or moustache with a fine 

comb before you star t trimming.

When you trim for the first time, be careful. Do not 

move the trimmer too fast. Make smooth and gentle 

movements.

Trimming with beard trimming comb

  1 

  Turn the Precision Zoom Lock 

`

 adjustment ring 

to the desired setting.  (Fig. 4)

See the table below for an over view of the settings and 

the resulting hair lengths. 

Setting

Resulting hair length

1

1mm

2

2mm

3

3.5mm

4

5mm

5

7mm

6

9mm

7

11.5mm

8

14.5mm

9

18mm

The setting appears in the window below the Precision 

Zoom Lock 

`

 adjustment ring. 

Note: When you trim for the first time, start at the highest 

setting (9) to familiarise yourself with the appliance.

  2 

  Switch on the appliance.

  3 

  To trim most effectively, move the trimmer against 

the hair growth direction. Make sure the surface 

of the comb always stays in contact with the 

skin (Fig. 5).

  4 

  If a lot of hair has accumulated in the beard  

trimming comb, remove the comb and blow and/or 

shake the hair out of it. The selected setting does 

not change when you do this (Fig. 6).

Never pull at the flexible top of the beard trimming 

comb. Always pull at the bottom part.

Trimming at the unique ‘stubble look’ setting

  1 

  To create a ‘stubble look’, trim with the beard 

trimming comb set to setting 1 (Fig. 7).

Trimming without beard trimming comb

Use the trimmer without beard trimming comb to trim 

full beards and single hairs.

  1 

  Pull the beard trimming comb off the 

appliance (Fig. 8).

Never pull at the flexible top of the beard 

trimming comb. Always pull at the bottom part.

  2 

  Switch on the appliance.

  3 

  Make well-controlled movements. Touch the hair 

lightly with the trimmer (Fig. 9).

Corded trimming

If the batter y is low, you can also use the appliance from 

the mains:

  1 

  Switch off the appliance, insert the adapter in the 

wall socket and wait a few seconds before you 

switch on the appliance.

Note: If the battery is completely empty, wait a few minutes 

before you switch on the appliance.

Cleaning

Never use scouring pads, abrasive cleaning agents or 

aggressive liquids such as alcohol, petrol or acetone to 

clean the appliance. 

  1 

  Make sure the appliance is switched off and 

disconnected from the mains.

  2 

  Remove the beard trimming comb.

  3 

  Open the cutting unit (Fig. 10).

  4 

  Clean the cutting unit and the inside of the 

appliance with the cleaning brush supplied (Fig. 11).

  5 

  Push the cutting unit back onto the appliance to 

close it (‘click’) (Fig. 12).

Note: The appliance does not need any lubrication.

Replacement

Only replace a worn or damaged cutting unit with an 

original Philips cutting unit, available from authorised 

Philips ser vice centres.

  1 

  Open the cutting unit.

  2 

  Pull the old cutting unit upwards to remove 

it (Fig. 13).

  3 

  Insert the two lugs of the new cutting unit into the 

guiding slots (Fig. 14).

  4 

  Push the cutting unit back onto the appliance 

(‘click’) (Fig. 12).

Environment

 - Do not throw away the appliance with the normal 

household waste at the end of its life, but hand it in 

at an official collection point for recycling. By doing 

this, you help to preser ve the environment (Fig. 15).

 - The built-in rechargeable batter y contains substances 

that may pollute the environment. Always remove 

the batter y before you discard and hand in the 

appliance at an official collection point. Dispose of 

the batter y at an official collection point for batteries. 

If you have trouble removing the batter y, you can 

also take the appliance to a Philips ser vice centre. 

The staff of this centre will remove the batter y for 

you and will dispose of it in an environmentally safe 

way.  (Fig. 16)

Removing the rechargeable battery

Only remove the rechargeable battery if it is completely 

empty.

  1 

  Disconnect the appliance from the mains and let 

the appliance run until the motor stops.

  2 

  Undo the screw in the housing of the 

trimmer (Fig. 17).

  3 

  Separate the 2 housing parts with a 

screwdriver (Fig. 18).

  4 

  Cut the wires close to the battery holder with a 

pair of household scissors (Fig. 19).

  5 

  Remove the battery holder with the rechargeable 

battery (Fig. 20).

  6 

  Use a screwdriver to pry the battery off the 

printed circuit board (Fig. 21).

Do not connect the appliance to the mains again after 

you have opened it.

Guarantee & service

If you need ser vice or information or if you have a 

problem, please visit the Philips website at  

www.philips.com

 or contact the Philips Consumer Care 

Centre in your countr y (you find its phone number in 

the worldwide guarantee leaflet). If there is no Consumer 

Care Centre in your countr y, go to your local Philips 

dealer.

EnGlIsH

2

4222.002.8021.3