BRAYER BR3401 - Инструкция по эксплуатации - Страница 9

9

EN

•  After learning the hair clipper better you will be able 

to use the attachment combs which leave shorter 

hair.

•  For even haircut make sure that the attachment 

comb fits closely to the head.

•  Slowly run the hair clipper through the hair, moving it 

in different directions, make overlapping movements 

to make sure that all areas of the hair on the head 

are trimmed.

•  Comb the hair along the direction of the growth to 

make it easier to cut them with the clipper.

•  For even haircut of wavy, thin or long hair, use the 

comb to direct the hair to the blade block (6).

•  From time to time clean the attachment comb from 

cut hair with the brush (15).

STEP ONE 

•  Install the attachment comb (11 or 12). Switch the 

hair clipper on by pressing the button (4) «   ». Hold 

the hair clipper with the blades pointed upwards. 

Start cutting from the hair growth edge. Slowly move 

the hair clipper upwards. Cut the back of the head 

area at the bottom and near the ears. 

• 

Notes:

 - to cut hair faster, switch the turbo mode on by 

pressing the button (7) «   », the symbol (2) «   » 

will light up. To switch the turbo mode off, press 

the button (7) «   » again, the symbol (2) «   » 

will go out. 

 - insert the power adapter (9) jack into the socket on 

the hair clipper body (pic. 1);

 - connect the power adapter (9) to the mains, the 

charging level digital symbols (3) and the symbol 

(8) «   » will light up;

 - wait for 2-3 minutes, switch the hair clipper on and 

continue cutting hair.

STEP TWO 

• 

Switch the hair clipper off, then set the attachment 

comb (13), switch the hair clipper on and continue 

cutting hair near top of the head. 

STEP THREE 

• 

Switch the hair clipper off, set the attachment comb 

(10 or 11) for shorter hair and cut hair on the temples. 

Switch the hair clipper off, then set the attachment 

comb (12 or 13), switch the hair clipper on and 

continue cutting hair towards the top of the head. 

STEP FOUR 

•  Cut the hair from the top of the head towards the 

crown against the hair growth direction. 

•  Use the attachments (10 or 11) for short haircut 

(3-6 mm). To leave slightly longer hair use the 

attachments (12 or 13) (9-12 mm). 

•  To leave longer hair, take hair locks between your 

fingers and cut it using the hair clipper. Lift the hair 

locks with the comb and cut them along the comb. 

•  Comb the hair to reveal uneven locks.