BRAYER BR3401 - Инструкция по эксплуатации - Страница 7

7

EN

•  Check the delivery set.

•  Examine the unit for damages, in case of damage do 

not plug it into the mains.

• 

Make sure that specified specifications of power 

supply voltage of the power adapter correspond to 

the specifications of your mains. When the unit is 

used in the mains with 60 Hz frequency, it does not 

need any additional settings.

•  The hair clipper can operate on the built-in 

rechargeable battery or on the power adapter. 

BATTERY CHARGING 

ATTENTION! 

Do not charge the battery at temperature below 0 °C 

and above +40 °C. 

HAIR CLIPPER STORING/CHARGING BASE (1)

• 

Before using the hair clipper for the first time it is 

recommended to fully charge the battery.

•  Insert the power adapter cord (9) jack into the base 

(1) socket, connect the power adapter (9) to the 

mains socket. 

•  Place the hair clipper on the base (1) (Pic. 1), the 

charging level digital symbols (3) and the symbol (8) 

«   » will light up. 

•  Full charging of the battery takes about 1.5 hours, 

when the battery is fully charged, the digital symbols 

(3) will show full charge level «99». After 3 minutes 

the digital symbols (3) will go out, and the symbol (8) 

«   »

 will start flashing

•  Disconnect the power adapter (9) from the mains.

•  Battery charging option 2

•  Insert the power adapter (9) jack into the socket on 

the hair clipper body (pic. 1a).

•  Connect the power adapter (9) to the mains, the 

charging digital symbols (3) and the symbol  

(8) «   » will light up. When the battery is fully 

charged, the digital symbols (3) will show full charge 

level «99». 

•  Unplug the power adapter (9), disconnect the power 

adapter (9) jack from the hair clipper body (pic. 1a).

• 

Notes: 

 - do not charge the battery for more than 6 hours;

 - if you didn’t use the hair clipper for more than 3 

months, fully charge the battery. 

BLADE BLOCK (6)

•  Detachable blade block (6) is consumable and is not 

covered by the warranty. 

• 

Clean the blade block (6) off cut hair and lubricate it 

after every use. It is also recommended to lubricate 

the blade block (6) before using the hair clipper. 

•  For lubricating the blades use the oil (14), supplied 

with the unit, or the oil intended for similar devices. 

•  Do not use vegetable oil or oil that contains solvents. 

Solvents will evaporate, and the remaining thick oil 

may slow down the blades motion.