VITEK VT-3966 B - Инструкция по эксплуатации - Страница 9

ENGLISH

9

press the REPEAT/MONO-ST button to 
improve sound quality, to switch on to the 
MONO mode.

ANTENNA

For the best FM reception, completely extend 
the FM ANTENNA (2, pic.). The device has a 
built-in antenna in order to receive AM signals. 
Turn the device left or right in order to achieve 
the best signal reception.

PROGRAMMING RADIO STATIONS

You can tune and store 20 stations in each band 
FM and MW (AM).
.  Select the band and tune to the station, 

which you want to program. 

2.  Press the MEMORY/CLK-ADJ button. The 

“MEMORY” indication and the “00” station 
indication will be flashing on the LCD display 
for 3 seconds.

3.  Use the PRESET/FOLDER 

 or 

buttons to select the station number from 
 to 20, under which you want to store the 
radio station.

.  Press the MEMORY/CLK-ADJ button again, 

to store the settings.

5.  Repeat steps  –  for all radio stations, 

which you want to store in memory. 

Note: you must select the station number 

while the MEMORY indication is flashing, 
otherwise the station will not be stored in the 
memory. If the indication disappears before 
you select the number of the station, repeat 
steps -.

PROGRAMMED RADIO STATIONS RECALL

To recall the programmed radio stations select 
the corresponding frequency band (FM or MW 

(AW)) and press the PRESET/FOLDER 

 or  

 buttons successively to select the desired 

radio station.
Note: The preset stations are stored in memory, 
while the device is plugged in and the battery is 
not low. When the power is off or the battery is 
low the preset radio stations will be erased from 
memory. You will need to program them again.

CD PLAYBACK

Loading – open the CD compartment lid. Insert 
a CD disc and close the CD compartment lid.
Ejecting – after the playback stops open the CD 
compartment lid and eject the disc. Put the disc 
in the case for storage.
Always close the CD compartment lid in order 
to prevent it from getting dust.  Always eject a 
disc from the CD compartment if it is not being 
played back. 
.  Switch on the cassette recorder by pressing 

the POWER button.

2.  Select the CD playback mode. To select it 

press the FUNCTION button successively 
until the “CD” indication appears on the LCD 
display.

3.  Open the CD compartment. Insert a CD disc 

and close the CD compartment. Number of 
tracks and total playback time will appear on 
the LCD display.

If after a CD disc have been inserted the “NO 
DISC” indication appears on the LCD display, 
check whether the disc is inserted properly. The 
disc should be inserted with the label up. 
.  To playback the disc from the first track 

press the PLAY/PAUSE button. 
You can select a track, which will be played 
back first. To do it, select a track using the 
SKIP TUNING 



 or 



 buttons, then press 

the PLAY/PAUSE button.

5.  To pause the playback, press the PLAY/

PAUSE button again. The “PLAY” indication 
and the playback time will be constantly 
flashing. To resume to playback mode press 
the button once again.

6.  To stop the playback, press the STOP 

button.

Note: if the CD compartment lid is open, the 

“OPEN” indication will appear on the LCD 
display.

PROGRAMMED PLAYBACK

You can program playback of tracks (max. 60 
tracks) in a desired sequence.
.  Switch on the cassette recorder by pressing 

3966IM.indd   9

07.07.2008   15:40:50