JVC KD-G447 - Инструкция по эксплуатации - Страница 8

8

ENGLISH

Using the standby receptions

  TA Standby Reception

TA Standby Reception allows the unit to switch 
temporarily to Traffic Announcement (TA) from any 
source other than AM.
The volume changes to the preset TA volume level if the 
current level is lower than the preset level (see
page 15).

To activate TA Standby Reception

The TP (Traffic Programme) indicator 
either lights up or flashes.

•  If the TP indicator lights up, TA Standby Reception is 

activated.

•  If the TP indicator flashes, TA Standby Reception is 

not yet activated. (This occurs when you are listening 
to an FM station without the RDS signals required for 
TA Standby Reception.)

  To activate TA Standby Reception, tune in to another 

station providing these signals. The TP indicator will 
stop flashing and remain lit.

To deactivate the TA Standby Reception

The TP indicator goes off.

  PTY Standby Reception

PTY Standby Reception allows the unit to switch 
temporarily to your favorite PTY programme from any 
source other than AM.

To activate and select your favorite PTY code for 
PTY Standby Reception,

 see page 15.

The PTY indicator either lights up or flashes.
•  If the PTY indicator lights up, PTY Standby Reception 

is activated.

•  If the PTY indicator flashes, PTY Standby Reception is 

not yet activated.

  To activate PTY Standby Reception, tune in to another 

station providing these signals. The PTY indicator will 
stop flashing and remain lit.

!

  Start searching for your favorite 

programme.

If there is a station broadcasting a programme 
of the same PTY code as you have selected, that 
station is tuned in.

Storing your favorite programme 

types

You can store six favorite programme types.

Preset programme types in the number buttons 
(1 to 6):

1

  Select a PTY code (see pages 7 and 8).

2

  Select the preset number (1 – 6) you want to 

store into.

3

  Repeat steps 1 and 2 to store other PTY codes 

into other preset numbers.

4

  Finish the procedure.

Ex.: When “ROCK M” is selected