Hyundai Electronics H-CMMD4042 - Инструкция по эксплуатации - Страница 51

51

DRC:

 set the DRC (dynamic range control) for better playback for low volume playback: On (use bass to play

the more dynamical audio), Off (normal playback).

Center delay:

the time difference between center and front speakers. The time delay makes audio signal more

accurate. Select the time delay: 0 ms (same time output with front speakers), 1 ms (1 millisecond delay), ..., 5 ms.

Rear delay:

 the time difference between rear and front speakers. The time delay makes surround effect more

better. Select the time delay: 0 ms (same time output with front speakers), 3 ms (3 milliseconds delay), ..., 15 ms.

Note:

REAR CTRL may be adjusted only when center speaker is set as small or large.

Down sampling:

 depending on the mode the signal output will be normal or 48 kHz. Select the mode: On (all

the signals will be 48 kHz), Off (all the signals will be normal).

ProLogic II

Pro Logic II is a dramatically improved matrix surround system based on the original Dolby Pro Logic system. In
the case of Pro Logic, there were four channels: front left, center and front right, plus a mono surround channel
that was usually split between two rear speakers. Compared to DPL, DPL II offers two full-range stereo surround
channels, more sophisticated steering logic, high channel separation and an exceptionally stable sound field. DPL
II uses a simple servo circuits used to derive the five channels. And, unlike the synthetic Jazz club, Hall and
Stadium modes found on many AV receivers, DPL II introduces no phony delay-induced echoes, reverb, or tonal
coloration.

1.  Enter the PRO LOGIC II menu.
2.  Use the 

 buttons on the panel or

8

/   buttons on the RC or touch

the desired item on the screen to select the settings: Surround mode,
Panorama, Dimension ctrl, Center width ctrl.

3.  Press the 

 buttons on the panel or

9

/

:

 buttons on the RC or touch

the desired button on the screen to enter the list of values.