Hyundai Electronics H-CDM8026 - Инструкция по эксплуатации - Страница 12

12

13

Operation

Operation

Radio operations

Band select

Press repeatedly BND/SUB button on the 

panel or 

 button on the RC to select your 

desired radio band during RADIO mode: FM1, 
FM2, FM3, AM1 (MW1), AM2 (MW2). In each 
set of the bands you can store up to 6 preset 
stations, making total 30 preset memory stations.

Auto/Manual tuning

Press and hold PREVIOUS/NEXT buttons 

on the panel or 

/

 buttons on the RC to 

automatically adjust the radio frequency. The 
radio will seek to the next up or down strong 
and clear frequency station. Repeat this action 
to seek for other desired stations. To adjust the 
needed frequency manually, press repeatedly 
PREVIOUS/NEXT buttons on the panel or 
/

 buttons on the RC.

Programming tuner stations

There are six numbered preset buttons, 

under which you can store and recall stations 
for each band. Select the needed station, 
then press and hold a preset button. The 
station will be saved in the memory under 
the corresponding number. To recall a stored 
station, press the corresponding preset button.

Automatic store/preset scan

Automatic store
Press and hold F/PS button on the panel 

or 

 button on the RC. The radio will 

automatically store the 6 strongest available 
stations to the 6 preset memories of the 3 FM 
bands or the 2 AM bands (depending on which 
one is current). To stop auto store, press this 
button again.

Preset scan
Press F/PS button on the panel or 

button on the RC, the receiver will scan the 
saved stations in the current band.

Mono/Stereo control 

(in FM radio 

mode)

Press SEL/

 button until the display shows 

ST ON (ST OFF). Turn VOLUME knob or press 

/

 buttons on the RC to switch between 

ON (stereo reception) or OFF (mono reception).

Improvement of reception of distant stations 

can be done by selecting mono mode, which 
may cut down some reception noise.

RDS function

RDS (Radio Data System) service availability 

varies with areas. Please understand if RDS 
service is not available in you area, the following 
service is not available, either.

AF (alternative frequencies) function

Press AF/

 button to turn the AF function 

on or off.

When the radio signal strength is poor, 

enabling the AF function will allow the unit to 
automatically search another station with the 
same PI (Program Identification) as the current 
station but with stronger signal strength, so that 
you do not have to retune the stations when 
driving between different transmitter coverage 
areas. When AF symbol is on, it means RDS 
information is received; when AF symbol is 
flashing, it means RDS information is not yet 
received.

PS (Program Service name): the name of 

station will be display instead of frequency.

If RDS service is not available in your area, 

turn off the AF mode. Default setting is ON.

TA (Traffic Alarm) function

Press TA/

 button to turn TA function on 

or off.

In TA mode traffic program will be 

automatically searched, until the program 
is received. When traffic announcement is 
received the unit will temporarily switch to the 
tuner mode (regardless of the current mode) 
and begin broadcasting the announcement. 
After the traffic announcement is over, it will 
return to the previous mode and volume level.