Einhell GE-CR 30 - Инструкция по эксплуатации - Страница 21

GB

- 21 -

2 or 1 LED(s) are lit:

The battery has an adequate remaining charge.

1 LED blinks:

The battery is empty, recharge the battery.

All LEDs 

fl

 ash:

The battery pack has undergone exhaustive di-

scharge and is defective. Do not use or charge a 

defective battery pack!

6. Operation

 Caution!

The device is equipped with a safety switch to 

prevent unauthorized use. Immediately before 

using the device, insert the safety plug (Fig. 5/

Item 5). Remove the safety plug again when inter-

rupting or terminating your work. To do so, press 

the lug (Fig. 5/Item A).

Danger! 

To prevent accidental start-up of the ma-

chine, the push-bar is equipped with a two-point 

switch (Fig. 10/Item A) which must be pressed 

before the lever switch (Fig. 10/Item B) can be 

pressed. If the lever switch is released, the machi-

ne switches o

ff

 . Repeat this process several times 

so that you are sure that your machine functions 

properly. Before you perform any repair or mainte-

nance work on the machine, ensure that the hoe 

blades are not rotating and that the power supply 

is disconnected. 

The equipment must be moved into operating 

position before you begin with your work. First pull 

the locking pin (Fig. 11/Item A) in the direction of 

the arrow as shown in Fig. 11 and swing up the 

wheel unit until the locking pin engages again in 

position B. Proceed in reverse order to move the 

equipment into transport position.

Always ensure that a safe distance (provided 

by the long handles) is maintained between the 

machine and the user. Be especially careful 

when changing direction on slopes and inclines. 

Maintain a solid footing and wear sturdy, non-slip 

footwear and long trousers. Always work along 

the incline (not up and down). 

Use special caution when backing up and pulling 

the machine (tripping hazard). 

6.2 Tips for proper working

Place the machine in front of the area you wish to 

hoe and hold it securely on the push bar before 

you switch on the machine. Guide the hoe blades 

over the area. 

To achieve cleanly hoed soil always ensure that 

you guide the machine in straight lines wherever 

possible. Insodoing, the aeration swaths should 

always overlap each other by a few centimeters in 

order to avoid bare strips. 

Switch o

ff

  the motor promptly when you arrive at 

the end of the area you wished to hoe. The motor 

must be switched o

ff

  when you raise the machine 

(for example to change direction). 

Keep the underside of the machine clean and re-

move soil deposits. Deposits make it more di

ffi

  cult 

to start the machine and decrease the working 

depth. Work perpendicular to the slop on inclined 

areas. The machine must be switched o

ff

  and the 

mains cable disconnected before you make any 

checks on the hoe blades. 

Warning! 

The hoe blades will continue to rotate for a few 

seconds after the motor is switched o

ff

 . Never att-

empt to manually stop them. In the event that the 

rotating hoe blade strikes an object, immediately 

switch o

ff

  the machine and wait for the hoe blades 

to come to a complete stop. Then inspect the con-

dition of the hoe blades. Replace any parts that 

are damaged. 

Anl_GE_CR_30_Li_SPK7.indb   21

Anl_GE_CR_30_Li_SPK7.indb   21

17.02.2017   09:45:52

17.02.2017   09:45:52