Einhell GE-CR 30 - Инструкция по эксплуатации - Страница 20

GB

- 20 -

5.  Before starting the equipment

Caution!

The equipment is supplied without batteries and 

without a charger is allowed to be used only with 

the lithium-ion batteries of the Power-X-Change 

series!

Power-X-Change

• 

18 V, 1.5 Ah, 5 lithium-ion cells

• 

18 V, 2.0 Ah, 5 lithium-ion cells

• 

18 V, 3.0 Ah, 10 lithium-ion cells

• 

18 V, 4.0 Ah, 10 lithium-ion cells

• 

18 V, 5.2 Ah, 10 lithium-ion cells

The lithium-ion batteries of the Power-X-Change 

series are allowed to be charged only with the 

Power-X charger.

Warning!

Always pull out the safety plug before making ad-

justments or carrying out maintenance, cleaning 

and repair work on the equipment.

Assembly (Figs. 3a-3g)

• 

Pull out the split pin (Fig. 3a/Item A) and re-

move the pin (Fig. 3a/Item B). Push the brake 

shoe (Fig. 3b/Item 12) into the mount and fix it 

in position with the pin and split pin previously 

removed.

• 

Undo the eight Philips screws (Fig. 3b/Pos. 

C) with washers on both sides of the axle. 

On both sides, push the transport wheel as 

shown in Fig. 3c onto the axle and secure 

with the Philips screws and washers (see Fig. 

3c inset).

• 

Press the wheel caps (Fig. 3d/Item 11) onto 

the transport wheels.

• 

Push the lower push bar as shown in Fig. 3e 

onto the motor unit (Fig. 3e/Item 3) and se-

cure with the screws (Fig. 3e/Item 9) and the 

star nuts (Fig. 3e/Item 8).

• 

Push the upper push bar (Fig. 3f/Item 1) onto 

the lower push bar (Fig. 3f/Item 2) and secure 

with the screws (Fig. 3f/Item 9) and the star 

nuts (Fig. 3f/Item 8).

• 

Secure the cable to the push bars with 2 

cable clips (Fig. 3g/Item 7).

Charging the battery (Fig. 4a/4b)

The equipment is supplied without batteries and 

without a charger.

1.  Take the battery pack out of the equipment. 

To do so, press the pushlock button (Fig. 4a/

Item C).

2.  Check that your mains voltage is the same as 

that marked on the rating plate of the battery 

charger. Insert the power plug of the charger 

into the socket outlet. The green LED will then 

begin to 

fl

 ash.

3.  Insert the battery pack into the charger.

4.  In the section entitled „Charger indicator“ you 

will 

fi

 nd a table with an explanation of the LED 

indicator on the charger.

The battery pack can become a little warm during 

the charging. This is normal.

If the battery pack fails to charge, check:

• 

whether there is voltage at the socket outlet

• 

whether there is good contact at the charging 

contacts.

If the battery pack still fails to charge, send

• 

the charging unit

• 

and the battery pack

to our customer service center.

To ensure that the battery pack provides long ser-

vice, you should take care to recharge it promptly. 

You must recharge the battery pack when you 

notice that the performance of the device drops. 

Never allow the battery pack to become fully di-

scharged. This will cause it to develop a defect.

Installing the battery (Fig. 4c-4d)

Open the battery cover. This is done by pressing 

the lock release (A) as shown in Fig. 4b and swin-

ging up the cover. Then connect the two batteries 

into the mounts as shown in Fig. 4d and push 

them forward until you hear the batteries engage.

Important!

Use only batteries which are charged to the same 

level. Never combine full and half-full batteries. 

Always charge the two batteries simultaneously.

The equipment‘s operating time depends on the 

battery with the lower charge level. The two bat-

teries must always be fully charged before use. 

Close the battery cover by swinging it down, and 

make sure that it latches in place correctly.

Battery capacity indicator (Fig. 4a)

Press the switch for the battery capacity indicator 

(Fig. 4a/Item A). The battery capacity indicator 

(Fig. 4a/Item B) shows the charge status of the 

battery using 3 LEDs.

All 3 LEDs are lit:

The battery is fully charged.

Anl_GE_CR_30_Li_SPK7.indb   20

Anl_GE_CR_30_Li_SPK7.indb   20

17.02.2017   09:45:52

17.02.2017   09:45:52