AL-KO MH 5065 R - Инструкция по эксплуатации - Страница 13

Safety instructions

441542_a

13

The machine must not be operated if the ope-

rator is under the influence of alcohol, drugs

or medication.
Observe  local  ordinances  regarding  opera-

ting times.
Work only when there is adequate daylight or

artificial lighting.

CAUTION!

Always  perform  a  visual  check  prior  to

start-up.

Use  the  machine  only  in  perfect  working  or-

der.
Note that the user is responsible for accidents

and damage caused to other persons and/or

their property
Do  not  deactivate  safety  and  protection  de-

vices
Do not place your hands and feet close to any

rotating parts.
Never lift or carry the mower while the motor

is running
Always ensure stability when working.
The  user  is  responsible  for  accidents  invol-

ving other people and their property.
Do not leave the appliance unsupervised.
Keep exhaust and engine clean.
Store petrol in designated containers only.
Only refuel in open air.
Replace  a  damaged  petrol  tank  and/or  tank

cap.
Only  replace  damaged  or  worn  parts  by  ge-

nuine spare parts.
Subject to changes in design and configura-

tion.
While  starting  the  engine  be  sure  that  is

nobody  standing  in  front  of  the  unit  or  its

working devices (weeding shares) – drive of

the weeding shares must be off.
Transport wheel is to be either installed or re-

moved and the breaking clutch is to be adjus-

ted only when the engine is off and the weed-

ing shares are not running.
When transporting it with the installed trans-

port wheel switch the engine off and wait until

the weeding shares stop.
The  unit  is  allowed  to  be  used  only  under

safety distances specified by the handgrip.
Always work transversely to the slope.

Never  work  up  and  down  the  slope  with  the

inclination angle bigger than 10°.
Never  open  the  cap  of  the  fuel  tank,  or  add

fuel, while the engine is running or the unit is

hot.
Use a funnel or a filler pipe when refuelling so

that no fuel is spilled on the engine, the deck

or the ground.
Do  not  start  the  engine  if  petrol  has  over-

flowed.  The  appliance  may  be  cleaned,  and

any  attempt  at  ignition  may  be  made,  only

when the petrol vapours have dissipated.
For safety reasons, never use the engine with

worn or damaged parts. Such parts must al-

ways  be  replaced,  not  repaired.  Use  OEM

spare parts. Spare parts of inferior quality can

damage the engine and endanger your safety
Renew exhaust silencers if damaged.
Do not change the engine governor settings.

STARTUP

Put the machine into operation only after its com-

plete assembly.

CAUTION!

Tank Oil and Petrol before the First Put-

ting into Operation! It´s necessary to re-

spect  unconditionally  instructions  in  en-

closed  operating  instructions  for  petrol

engine delivered by engine producer.

Setting-up of Handle Height

Set-up  handle  height  according  to  your  proper

body size.
Common  setting-up  of  height  corresponds  to

haunch height.

Loose screws on cover support.
Set-up handle height according to long holes.
Tighten screws.

Transport Wheel

Motor cutter can be transported to given place by

means of transport wheel.
If  you  will  operate  the  motor  cutter,  remove  the

transport wheel or fix it into upper grip .

Engine Start

At engine start, clutch lever of weeder share can’t

be activated!

Set-up saturator lever into position "START"
Pull out quickly starter cable and afterwards,

let it slowly wind up!