Bort BFP-350 - Инструкция по эксплуатации - Страница 7

7

GB

Electric airless spray gun

THE NUMBERS MENTIONED IN THE TEXT 
CORRESPOND WITH THE PICTURE SAT PAGE2.

TECHNICALSPECIFICATIONS

Voltage

230 V ~

Frequency

50 Hz

Powerinput

350 W

Maximum nozzle 

fl

 ow rate 

200 g/min

Container capacity

600ml

Weight

2,6kg

PRODUCT INFORMATION   

 A 

1. Motor housing
2. Output control
3. Triggerswitch
4. Handle
5. Paintcontainer
6.  Spray basket nozzle
7. Viscositycup

SAFETY INSTRUCTIONS

The following symbols are used in these instructions 
for use:

Denotes risk of persona! injury, loss of life or 
damage to the tool in case of non-observance 
of the instructions in this manual.

Denotes risk ofelectric sh ock.

Carefully read this manual before using the machine. 
Make sure that you know how the machine functions 
and how to operate it. Maintain the machine in accord-
ance with the instructions to make sure it functions 
properly. Keep this manual and the enclosed documen-
tation with the machine.

Electrical safety
Warning! When usingelectric tools, basic safety 
precautions should always be followed to reduce 
the risk of 

fi

 re, electric shock and personal injury. 

Read all these instructions before attempting to 
operate this product and save these instructions.

Always check that the mains voltage corre-

sponds to the voltage on the rating plate.

The machine is double insulated in accord-
ance with EN 50144; therefore no earth wire is 
required.

No connection should be made to the earth 
terminal of the plug. A 3 amp fuse should be 

fi

 tted. There are no user serviceable parts 

inside. Always refer to quali

fi

 ed service personnel. 

Do not allow this spray gun to be exposed to rain.

Replacing cables or plugs

Immediately throw away old cables or plugs when they 
have been replaced by new ones. It is dangerous to 
insert the plug of a loose cable in the wall outlet.

Using extension cables

Only use an approved extension cable suitable for the 
power input of the machine. The minimum conductor 
size is 1.5 mm

2

. When using a cable reel always un-

wind the reel completely.

ADDITIONAL SAFETY INSTRUCTIONS

-  NEVERSPRAY AT PERSONS- Neveraim the nozzle 

at another person or animal. Never allow the spray 
to come in to direct con tact with the skin.

  FLASH POINT - This spray gun must not be used for 

spraying 

fl

 ammable paints and solvents with a 

fl

 ash 

point of less than 32°C

  VENTILATION - Always make sure that there is ad-

equate ventilation in the work area when spraying.

-  BASKET NOZZLE - Always keep the spray basket 

nozzle in piace during use.

-  CONSIDER WORK AREA ENVIRONMENT - Do not 

use spray guns where there is a risk of 

fi

 re or explo-

sion.

-  BEWARE OF ANY HAZARD - Beware of any hazard 

by the material being sprayed and consult the mark-
ings on the container or the information supplied by 
the manufacturer.

-  DO NOT SPRAY-Do not spray any material where 

the hazard is notknown.

-  USE EYE PROTECTION - Always use appropriate 

eye protection to keep hazardous vapours or fumes 
out of the eyes.

-  WEAR A MASK - Never operate a spray gun without 

wearingaface mask.

-  PROTECT YOUR EARS - Wear ear protectors if the 

sound pressure exceeds 85 dB(A).

-  MAINTAIN YOUR TOOLS - Keep your spray gun, 

paint container and nozzles clean. Do not clean with 

fl

 ammable liquids with a 

fl

 ash point less than 32°C 

Inspect the mains lead periodically and if damaged 
have it replaced by a quali

fi

 ed person.

-  NAKED FLAMES - Never spray near a naked 

fl

 ame 

or appliance pilot

fl

 ame.

-  SMOKING - Neversmokewhilstspraying. THINNING 

- Always read the paint manufacturers thinning rec-
ommendations or instructions before using paint or 
other materials.

-  DISCONNECT FROM THE MAINS SUPPLY - Al-

ways disconnect from the mains supply when 

fi

 lling 

the paint container or cleaning the spray gun.

English