Tesla TA36FFML - Инструкция по эксплуатации - Страница 44

44

ENG

Drain pipe connection

Wrap the Piping

1.  Remove the fixed part to pull out pipe of indoor machine from the case. Screw the hexagon nut in the left of the 

joint to the end with your hand.

2.  Connect the connecting pipe to the indoor unit: 

Aim at the pipe center, tighten the Taper nut with fingers, and then tighten the Taper nut with a torque wrench, 
and the direction is shown in diagram on the right. The torque used is shown in the following table.

Note

: Carefully check if there is any damage of joints before installation.

The joints shall not be reused, unless after re-flaring the pipe.

1.  Use the insulation sleeve to wrap the joint part the indoor 

unit and the connection pipe, and then use insulating 
material to pack and seal insulation pipe, to prevent 
generation of condensate water on the joint part.

2.  Connect the water outlet with drain pipes, and make the 

connection pipe, cables, and the drain hose straight.

3.  Use plastic cable ties to wrap the connecting pipes, cables 

and drain hose. Run the pipe sloping downward.

The size of pipe (mm)

Torque (Nm)

ɸ

6 / 

ɸ

6. 35

15 ~ 88

ɸ

9 / 

ɸ

9. 52

35 ~ 40

ɸ

12 / 

ɸ

12.7

45 ~ 60

ɸ

15.88

73 ~ 78

ɸ

19.05

75 ~ 80

Tightening torque table

Indoor unit pipe

Spanner

Torgue wrench

Connecting Pipe
Drain Hose
and Cables

Plastic Strap

Taper nut Connecting 

pipe

Fixing the Indoor Unit

1.  Hang the indoor unit on the peg board, and move the 

unit from left to right to ensure that the hook is properly 
positioned in the peg board.

2.  Push toward the lower left side and the upper right side of 

the unit toward the peg board, until the hook is embedded 
in the slot and makes a “click” sound.