Tesla TA36FFML - Инструкция по эксплуатации - Страница 43

43

ENG

Mounting plate

Wall-through Hole

Route of Pipeline

1.  The wall for installation of the indoor unit shall be hard and 

firm, so as to prevent vibration.

2.  Use the “+” type screw to fasten the peg board, horizontally 

mount the peg board on the wall, and ensure the lateral 
horizontal and longitudinal vertical.

3.  Pull the peg board by hand after the installation, to confirm 

whether it is solid.

1.  Make a hole with an electric hammer or a water drill at the 

predetermined position on the wall for piping, which shall 
slant outwardly by 5° -10° .

2.  To protect the piping and the cables from being damaged 

running through the wall, and from the rodents that may 
inhabit in the hollow wall, a pipe protecting ring shall be 
installed and sealed with putty.

Note

: Usually, the wall hole is 

ɸ

60mm~

ɸ

80mm. Avoid pre-

buried power wire and hard wall when making the hole.

1.  Depending on the position of the unit, the piping may be routed sideway from the left or the right (Fig 1), or 

vertically from the back (Fig 2) (depending on the pipe length of the indoor unit). In the case of sideway routing, 
cut off the outlet cutting stock of the opposite side. 

Pipe protection 

ring

Connecting Pipe

Drain Hose and 

Cables

Connecting Pipe

Drain Hose and 

Cables

Outlet material preparation

Fig 2

Putty

Fig 1