Neoclima NS-07 - Инструкция по эксплуатации - Страница 66



 Page 27



Outdoor Unit 

  Installation

Step 2: Install drain joint(Heat pump unit only)

Before bolting the outdoor unit in place, you must  

install the drain joint at the bottom of the unit.

Note  that there are two different types of drain 

joints depending on the type of outdoor unit. 

If the drain joint comes with a rubber seal

(see 

Fig.  A 

), do the following:

1.

 Fit the rubber seal on the end of the drain joint 

that will connect to the outdoor unit.

2.

Insert the drain joint into the hole in the base 

pan of the unit.

3.

 Rotate the drain joint 90° until it clicks in place 

facing the front of the unit.

4.

 Connect a drain hose extension (not included) 

to the drain joint to redirect water from the 

unit during heating mode.

If the drain joint doesn’t come with a rubber 

seal 

(see 

Fig. B 

), do the following: 

1.

 Insert the drain joint into the hole in the base 

pan of the unit. The drain joint will click in 

place.

2.

 Connect a drain hose extension (not included) 

to the drain joint to redirect water from the 

unit during heating mode.

Seal

Drain joint

(A)

(B)

Base pan hole of

outdoor unit

Seal 

 IN COLD CLIMATES 

In cold climates, make sure that the drain hose 

is as vertical as possible to ensure swift water 

drainage. If water drains too slowly, it can 

freeze in the hose and flood  the unit.

The outdoor unit can be anchored to the 
ground or to a wall-mounted bracket with 
bolt(M10). Prepare the installation base of the 
unit according to the dimensions below. 

A

W

B

D

Air inlet

Air outlet

Air inlet

W

H

Step 3: Anchor outdoor unit

UNIT MOUNTING DIMENSIONS

The following is a list of different outdoor 
unit sizes and the distance between their 
mounting feet. Prepare the installation base 
of the unit according to the dimensions 
below.